Jun Xiao

Jun Xiao

Auto-generated profile, based on publicly available information

Jun Xiao

National Key Laboratory of Nuclear Reactor Technology, Nuclear Power Institute of China, Chengdu, People’s Republic of China, 610213

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 February 2026 in Corrosion Science
Verified
Journal Article
Closed access
KZKe Zhao
Ke Zhao
JXJun Xiao
Jun Xiao
YSYuanhua Shen
Yuanhua Shen
HWHao Wang
Hao Wang
YZYuqi Zheng
Yuqi Zheng
YLYongwang Li
Yongwang Li

4 December 2024 in Corrosion
Verified
Journal Article
Closed access
JXJun Xiao
Jun Xiao
YZYu Qi Zheng
Yu Qi Zheng
TXTing Xiao
Ting Xiao
HWHao Wang
Hao Wang
QXQi Xu
Qi Xu
The predeformed 316NG (00Cr17Ni12Mo2N) was prepared by cold rolling at room temperature and hot rolling at 400°C. The effect of predeformation on fatigue crack growth both in 325°C deaerated water and room temperature air was investigated. The effect of predeformation on corrosion fatigue crack growth (CFCG) in 325°C deaerated water was much smaller than that on fatigue crack growth. The cold rolling significantly enhanced CFCG rates while the applied ΔK closed to 11 MPa√m or the applied loading frequency decreased to 0.1 Hz. The accelerating effect of hot rolling on CFCG tended to become evident until the predeformation increased to 30%. Dynamic recovery was observed near the corrosion fatigue crack tip in hot-rolled 316NG, which may result in relatively low CFCG rates.

31 March 2026 in Corrosion
Verified
Journal Article
Closed access
PDF file
TXTing Xiao
Ting Xiao
JXJun Xiao
Jun Xiao
YZYu Qi Zheng
Yu Qi Zheng
QXQi Xu
Qi Xu
SQShao Yu Qiu
Shao Yu Qiu
Corrosion fatigue crack growth (CFCG) of thermally aged Z3CN20-09M cast austenitic stainless steel (CASS) was studied in simulated pressurized water reactor (PWR) primary water. Specimens were aged at 400°C (6,000 h and 16,000 h) and 450°C (6,000 h) and tested under varied loading conditions. The PWR primary water increased crack growth rates by typically up to 15 times compared to air, due to synergy between cyclic loading, corrosion, and the duplex microstructure, yet with weaker frequency and stress intensity dependence than conventional austenitic steels. Thermal aging had a limited influence (acceleration factor < 4), indicating that ferrite decomposition does not substantially affect the crack-tip oxide film (inner spinel/outer magnetite bilayer) or its rupture behavior. The study further establishes that all measured corrosion fatigue crack growth rates consistently fall below the ASME Code Case N-809 design curve, validating its continued applicability as a conservative safety benchmark for aged CASS components in PWR environments.

26 January 2026 in Corrosion Science
Verified
Journal Article
Closed access
YZYuqi Zheng
Yuqi Zheng
JXJun Xiao
Jun Xiao
TXTing Xiao
Ting Xiao
WMWanli Ma
Wanli Ma
JLJingjing Liao
Jingjing Liao
QXQi Xu
Qi Xu

10 June 2026 in Journal of Nuclear Materials
Verified
Journal Article
Closed access
JXJun Xiao
Jun Xiao
TXTing Xiao
Ting Xiao
XZXiang Yu Zhong
Xiang Yu Zhong
YZYu Qi Zheng
Yu Qi Zheng
HKHiroshi Kakinuma
Hiroshi Kakinuma
TSTetsuo Shoji
Tetsuo Shoji

18 March 2026 in SSRN Electronic Journal
Verified
Preprint
Open access
JXJun Xiao
Jun Xiao
TXTing Xiao
Ting Xiao
XZXiang-Yu Zhong
Xiang-Yu Zhong
YZYu Qi Zheng
Yu Qi Zheng
HKHiroshi Kakinuma
Hiroshi Kakinuma
TSTetsuo Shoji
Tetsuo Shoji
The influence of thermal aging on the corrosion behavior of type Z3CN20-09M cast austenitic stainless steel was systematically investigated in simulated pressurized water reactor (PWR) primary water (325 °C, 2 ppm Li, 500 ppm B). Following aging at 325 °C for 6000 h, approximately 75% of the initially contained hydrogen (1.78 ppm) was released, yet it exhibited no measurable impact on corrosion performance. Decomposition of the ferrite markedly accelerated corrosion in a phase-dependent manner, with the austenite phase demonstrating comparatively higher susceptibility to oxidation compared to the ferrite phase. Upon pronounced spinodal decomposition of the ferrite phase (e.g., after aging at 400 °C/16,000 h or 450 °C/6000 h), the oxide film thickness on austenite nearly doubled, whereas the ferrite phase displayed a less than twofold increase in oxide scale growth. Characterization of the oxide/metal interface revealed alternating FeCr₂O₄-rich and Cr₂O₃-rich zones, which directly closely correlated with Cr-rich and Fe-rich fluctuations produced by the spinodal decomposition of ferrite. These findings indicate that thermal aging enhances micro-galvanic coupling between phases, thereby accelerating the corrosion of duplex stainless steels in PWR-relevant environments.