Sang-Goo Lee

Sang-Goo Lee

Auto-generated profile, based on publicly available information

Sang-Goo Lee

BULe Photonics Company Ltd., Incheon, Republic of Korea

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2024 in AIP Advances
Verified
Journal Article
Open access
PDF file
BKByungjin Kwon
Byungjin Kwon
SPSeonghun Pyo
Seonghun Pyo
YJYub Je
Yub Je
HSHee-Seon Seo
Hee-Seon Seo
SLSanggoo Lee
Sanggoo Lee
Yongrae RohYongrae Roh
Yongrae Roh
Recently, there has been a surge of interest in [011]-poled Mn: PIN-PMN-PT piezoelectric single crystals for high-power transducers. These crystals boast impressive electromechanical coupling coefficients, piezoelectric constants in the transverse mode, and excellent heat resistance due to their high mechanical quality factor. To effectively design transducers using these crystals, understanding their material constants is crucial. Our study focused on determining these constants by employing the resonance method. We created eleven different resonators, analyzed their impedance spectra, and derived seventeen elastic compliance, piezoelectric, and dielectric constants. The precision of the obtained material constants was enhanced by minimizing the difference between the impedance spectra found through finite element analyses and actual measurements of each resonator. The accuracy of these derived constants was validated by comparing the impedance spectra obtained from analysis with those measured experimentally. This novel approach demonstrated a capability to derive more precise material constants than prior studies. These refined material constants hold the potential to enable more precise and effective design of acoustic transducers constructed from the single crystals.

1 April 2026 in IEEE Sensors Journal
Verified
Journal Article
Open access
HSHayeong Shim
Hayeong Shim
YCYohan Cho
Yohan Cho
SLSang-Goo Lee
Sang-Goo Lee
YJYub Je
Yub Je
Piezoelectric single crystals, with their high electromechanical coupling coefficient (k33 ≈ 0.9) and large piezoelectric constant (d33 > 1500 pC/N), have been actively researched for acoustic transducers to achieve high efficiency and broadband performance. However, despite their superior piezoelectric properties, the application of single crystals to high-power transducers has been restricted by limitations in driving field, temperature, and mechanical stress. To overcome these limitations, this study designed and experimentally validated a 32-mode Tonpilz transducer using [011]-poled single crystals, which exhibit higher electrical stability than the commonly used [001]-poled single crystals in 33-mode devices. The coercive field of [011]-poled single crystals was measured to be 8.81 kV/cm under 30 MPa-compressive stress—approximately twelve times higher than that of [001]-poled crystals. Based on these results, a 32-mode Tonpilz transducer was designed using [011]-poled PIN-PMN-PT single crystals. The design combined the longitudinal resonance of the piezoelectric stacks with the flapping mode of the head mass to broaden the bandwidth, while electrical and mechanical stress limits were considered to enable high-power operation. The fabricated transducer was experimentally characterized, showing good agreement between simulation and measurement, and source level measurements confirmed linear operation up to 1500 Vrms. These results demonstrate that [011]-poled single crystal-based transducers are promising candidates for high-power underwater acoustic projectors.

15 April 2025 in Journal of Applied Physics
Verified
Journal Article
Open access
WCWoo-Jin Choi
Woo-Jin Choi
HYHye-Lim Yu
Hye-Lim Yu
JSJeong-Woo Sun
Jeong-Woo Sun
SLSang-Goo Lee
Sang-Goo Lee
YJYoon-Sang Jeong
Yoon-Sang Jeong
WJWook Jo
Wook Jo
The thickness of the piezoelectric single crystals is known to have a significant impact on their piezoelectric properties. For high-performance transducers used in high-frequency medical diagnostic applications, the thickness of the piezoelectric single crystals must be reduced. However, the scaling effect, where the piezoelectric and dielectric properties deteriorate as the thickness decreases, remains insufficiently understood, and the mechanisms underlying this phenomenon are unclear. To address this issue, we investigated the changes in polarization and dielectric properties and the underlying mechanism of the scaling effect in alternating current (AC)-poled rhombohedral [001]-oriented 0.72Pb(Mg1/3Nb2/3)O3–0.28PbTiO3 (PMN–28PT) single crystals with respect to the sample thickness. The typical scaling effects, commonly observed with decreasing sample thickness, were confirmed through the degradations in polarization and dielectric properties of AC-poled crystals. The AC-poled crystals exhibited 109.5° domain walls parallel to the (001) plane, and the domain sizes in the surface layer were more than double those in the inner region regardless of thickness. The larger domain size in the surface layer reduces the density of the relatively soft 109.5° domain boundaries, thereby it causes an increase in the coercive field and degradation of the dielectric properties as the thickness decreases. The accumulated space charge on the surface induced an internal bias field for the thin samples, which is considered the origin of the large 109.5° domain size in the surface layer by applying the clamping pressure on the domains within that layer. This unexplored mechanism could contribute to solving the scaling effect problem in PMN–28PT single crystals for high-frequency ultrasound biomicroscope applications.