1 February 2007 in Journal of Constructional Steel Research
1 April 2010 in Journal of Structural Engineering
Plate steel shear links offer enhanced design freedom, including the ability to use steel grades that are not available in rolled shapes. This paper discusses the cyclic response of five types of shear links designed using steel grades that ranged from 485 to 100 MPa yield strength. The design and subsequent performance was categorized into two groups; conventional design and those designed without stiffeners using low yield point steels. Ductile failure modes and desirable hysteretic behavior that resulted in efficient cyclic energy dissipation were observed for all specimens. The links designed without stiffeners using low yield point steel reached shear deformations exceeding 0.20 rad, outperforming the conventional designs that exhibited approximately 0.12 rad capacity. The enhanced performance was the result of shifting the failure mode by excluding intermediate stiffeners and providing low web compactness. This combination eliminated welding and decreased measured plastic strain demands on the face ...
1 June 2007 in Journal of Materials in Civil Engineering
MSMahmoud Sadrossadat-Zadeh
Mahmoud Sadrossadat-Zadeh
This paper discusses the superelastic behavior of shape memory alloy, Nitinol (NiTi) , when used as reinforcement in concrete beams. The ability of NiTi to recover and reduce permanent deformations of concrete beams was investigated. Small-scale concrete beams, with NiTi reinforcement were tested under half-cycle loads. The reinforcement ratio varied from 0.1 to about 0.9%. The experimental results showed that the average residual displacement in the NiTi reinforced beams was less than one-fifth of that of the steel reinforced test beams. The stiffness of NiTi reinforced test beams however was lower than those of the steel reinforced test beams. An analytical study of load–deflection relationship for a series of hybrid beams was undertaken. It was found that a hybrid system that incorporated NiTi combined with high strength steel or carbon fiber reinforced plastic bars was a better choice for design because of their relatively high stiffness.
1 April 2018 in Journal of Structural Engineering
This study conducts shake table studies and analysis of a large-scale novel posttensioned (PT) precast bridge column connected to a precast footing with a pocket connection. The primary objective is to develop a resilient square precast bridge column with minimal residual lateral displacement and plastic hinge damage when subjected to strong earthquakes. Another objective is to evaluate a column-footing pocket connection. The column is posttensioned with unbonded carbon fiber–reinforced polymer (CFRP) tendons to eliminate permanent drifts. To mitigate seismic damage, ultra-high performance concrete (UHPC) is used in the plastic hinge zone of the column. The column model is subjected to the 1994 Northridge-Rinaldi earthquake record with increasing amplitudes until failure. Experimental results show that the drift ratio and displacement ductility capacity of the column are 6.9 and 13.8%, respectively, and the residual displacement is negligible. Furthermore, the pocket connection is effective in forming the plastic hinge in the column with no connection damage. Another finding of the study is that available fiber element models lead to close correlation between the measured and calculated responses.
1 October 2006 in Journal of Engineering Education
1 August 2013 in Earthquake Spectra
Severe damage to acceleration sensitive nonstructural components in recent earthquakes has resulted in unprecedented losses. Recent research has been aimed at increasing the understanding of acceleration demands on nonstructural components in buildings. This investigation subjects a set of four special moment resisting frame (SMRF) building models to a suite of 21 far‐field ground motions using the incremental dynamic analysis procedure. Full three‐dimensional models including floor slabs are used to extract both the horizontal and vertical responses. Floor acceleration response spectra are generated to assess the acceleration demands on elastic nonstructural components. Changes to the current code provisions that include the influence of structural period are proposed. An alternative design approach that directly amplifies the ground acceleration spectrum to achieve the desired floor acceleration spectrum is presented.