Additive manufacturing (AM) tools are capable of applying overlay austenitic stainless steel (SS) claddings to carbon steel components. The benefits of this approach over arc welding include a smaller heat-affected zone, residual stress reduction, and material savings. In particular, wire-directed energy deposition is a suitable technique because of its low material cost and high rate of production compared to other AM methods. However, metallurgical variations in composition, phase fraction, and microsegregation can potentially influence the corrosion behavior of such claddings. In this work, 309L SS is clad on carbon steel substrates and electrochemical methods are used to measure their general and pitting corrosion resistance in simulated marine environments (3.5 wt% NaCl solutions). Two-layer claddings are fabricated with four laser powers to understand the effects of bulk chemical composition, austenite/δ-ferrite phase fractions, and individual phase compositions on corrosion behavior. The two-layer claddings are compared to a single-layer cladding, wrought 304 SS, and the carbon steel substrate for a comprehensive assessment of corrosion performance. The two-layer claddings are remarkably resistant to general corrosion in the 3.5 wt% NaCl environment because of their high Cr content (21.6 wt% to 23.3 wt% Cr). The single-layer cladding exhibits localized corrosion at unmixed Fe-rich peninsulas that originate at the dissimilar metal boundary and protrude into the first cladding layer. All two-layer claddings possess higher pitting corrosion resistance than wrought 304 SS, demonstrating their effectiveness as a corrosion-resistant barrier. The pitting corrosion resistance is superior for claddings made with lower laser powers, due to low dilution and greater δ-ferrite contents.
Alloy 625 is employed in light water reactors, advanced reactor concept designs, and radioactive waste storage applications where long-term microstructural stability is critical. Prolonged thermal exposure between ~330 and 700 °C can promote the formation of an embrittling long-range ordered Ni2(Cr,Mo) phase, potentially limiting component service lifetimes. In this research, we isothermally age Alloy 625 between 330 and 475 °C for up to 50,000 hours to investigate its early-stage ordering and impacts on microstructure and mechanical response. Microstructural evolution is characterized using synchrotron x-ray diffraction (XRD), microhardness, and transmission electron microscopy (TEM). XRD measurements disclose systematic matrix lattice contraction with increased aging time and hardening is raised by 28%; however, distinct superlattice reflections associated with Ni2(Cr,Mo) are not resolved for any aging condition. TEM analysis reveals nanoscale precipitates and diffraction signatures associated with long-range ordering following extended aging at 418 and 475 °C. These results show that low volume fractions and nanoscale dimensions of Ni2(Cr,Mo) limit the appearance of well-defined superlattice reflection peaks in bulk XRD measurements. A second round of Rietveld refinements incorporating the Ni2(Cr,Mo) phase is then performed to estimate its volume fraction, comparing with TEM observations and equilibrium thermodynamic simulations. Our combined analysis demonstrates the complementary nature of diffraction and microscopy for resolving early-stage ordering phenomena and that significant ordering in Alloy 625 develops at nanometer length scales prior to the emergence of resolvable superlattice reflections in conventional XRD measurements, providing new insight into the interpretation of diffraction data and the alloy’s long-term stability in nuclear environments.
10 October 2026 in Journal of Alloys and Compounds