19 July 2018 in Journal of Materials Chemistry A
Lithium metal is one of the most attractive anode materials, due to its high theoretical specific capacity and lowest electrochemical potential. However, low coulombic efficiency and serious safety hazards have still hindered the wide applications of next-generation batteries including Li–S and Li–air. Previous studies have suggested overcoming the problem by applying various structures of current collectors. These structures homogenize the Li ion flux or provide space for volume expansion. However, there are some limitations to solving problems occurring at the Li metal surface, because the current collector is underneath the structures of Li metal. In this work, we propose a facile and cost-effective strategy for stabilizing the lithium metal–electrolyte interface via a three-dimensional stainless steel mesh (SSM) interlayer. Its high specific surface area lowers the local current density and provides an electronic flow path for dead Li. Also, this structure leads to confinement of Li deposits and alleviates volume expansion. As a result, the Li anode with the SSM interlayer operated at current densities of 1 mA cm−2 (1C rate) and 5 mA cm−2, and it exhibited a longer cycle-life than planar structures in a symmetrical cell configuration.
2 May 2020 in Sustainable Energy & Fuels
Lithium metal is considered the most promising anode material because of its highest theoretical capacity and lowest electrode potential among the candidate materials. However, Li metal batteries have not been commercialized yet owing to their poor cycle stability. To solve this problem, many studies have reported that the addition of chemically stable LiF to the artificial solid electrolyte interphase (SEI) layer can effectively inhibit the low irreversibility of and dendrite growth on Li metal. However, this measure is inadequate for achieving the desired performance, and it introduces difficulties in the fabrication process. This study employs an in situ LiF protective layer (PL) to stabilize the surface of Li metal. This artificial SEI layer that includes LiF can be fabricated simply through thermal curing of an F-rich material on the surface of Li metal. This “in situ LiF PL” effectively prevents volume expansion of Li metal, resulting in a capacity retention of 52.1% after 1000 cycles at 5.0C. The proposed artificial SEI layer design offers an alternative strategy for stabilizing the surface of Li metal.
5 December 2017 in Journal of Materials Chemistry C
Highly flexible and stretchable graphene-based fibers are one of the most synthetically challenging materials that are suitable for next-generation wearable electronics. Graphene-based fibers used in reliable wearable devices should be multifunctional and stable. Here, we report an easy-handling fabrication method for reduced graphene oxide fibers containing semiconducting CuI and metallic Cu particles (CRGO fiber). The fibers were prepared by wet spinning and hydriodic acid treatment from a CuCl2–ethylene glycol coagulating solution without pre-synthesized CuI and Cu particles. The fabricated CRGO fibers exhibited chemical sensitive/temperature insensitive or chemical insensitive/temperature sensitive characteristics, depending on the Cu concentration in the CRGO. This is the first demonstration of a highly selective chemical and temperature sensor with sensitivity-switching properties fabricated from twisted CRGO fibers comprising two fiber bundles with low and high Cu concentrations.