Chitosan-reinforced starch-based biodegradable composite films were prepared by solution casting. The chitosan content in the films was varied from 20% to 80% (w/w). Tensile strength (TS) and tensile modulus (TM) of the starch-based composites were improved significantly with the addition of chitosan. Water vapor permeability (WVP) and oxygen transmission rate (OTR) of chitosan-reinforced starch-based films showed a significant reduction compared to native chitosan film and indicated better barrier properties to water vapor and oxygen. The water uptake of the films pointed out better hydrophobic character due to the incorporation of chitosan in starch-based films. Thermal stability was also found to increase with the addition of chitosan in starch-based films and was confirmed by thermogravimetric analysis (TGA) and differential thermal analysis (DTA). Fourier transform infrared (FT-IR) spectroscopy supported the molecular interactions due to the reinforcement of chitosan in starch-based films. Surface and interface morphologies of chitosan film and starch/chitosan composite film were examined by scanning electron microscope (SEM) and suggested sufficient homogenization of starch and chitosan in the biodegradable composite films.
The mechanical properties of the coir fibers were evaluated in this study. Tensile strength (TS), Young’s modulus (YM) and elongation at break (Eb%) of virgin coir fibers were found to be 152 MPa, 5.3 GPa and 36%, respectively. Coir fibers were treated with ultraviolet (UV) radiation and were found to improve the mechanical properties significantly. Coir fiber-reinforced ethylene glycol dimethacrylate (EGDMA)-based composite was prepared and characterized. The surface of the coir fibers was modified with monomer EGDMA under UV radiation. Soaking time, monomer (EGDMA) concentration and radiation intensities were optimized over mechanical properties. The highest values of TS, YM, Eb and polymer loading (PL) were found for 50% EGDMA at 125th pass of UV radiation for 7 min soaking time. Pretreatment with UV radiation on the coir fiber was found to be more effective for the increment of its mechanical properties. The surface of the fiber was also mercerized (alkali treatment) using aqueous NaOH solutions (5–50%) at varied time and temperature. It was found that TS of the mercerized composites increased with the increase in NaOH solutions (up to 10%) and then decreased. The composites made using mercerized fibers treated with EGDMA showed further increase in TS. Pretreatment with mercerization + UV treatment of coir fiber showed significant improvement in the mechanical properties of the coir fiber-based composites.