6 January 2025 in IEEE Transactions on Industrial Electronics
Zero-sequence current excited memory machine (ZSCE-MM) employs transient zero-sequence current (ZSC) to change the magnetization state of low-coercive-force (LCF) magnet. Hence, the torque density improvement and flexible flux regulation can be realized simultaneously without requiring additional magnetizing winding as well as associate current controller. However, this advantage of ZSCE-MM cannot be fully utilized through the traditional virtual voltage vector based-space vector modulation (V3-SVM) strategy, which constrains the ZSC generation ability. Consequently, a novel V3-SVM based on virtual voltage vector reconstitution technology with high dc-link voltage utilization is proposed for ZSCE-MM drive, while the simple identification progress is also preserved. Since the virtual voltage vector is expanded from the 0-axis to 3-D space, the linear modulation region in 3-D space can be enlarged. The proposed novel V3-SVM strategy can generate a higher amplitude of ZSC under the on-load situation, which means a wider flux regulation region can be achieved which is beneficial for global efficiency improvement of ZSCE-MM. The effectiveness of proposed novel V3-SVM strategy is validated by both simulation and experimental results.
14 October 2025 in IEEE Transactions on Transportation Electrification
Due to high dc-link voltage utilization and less required power devices, series-end winding machine drives have potential applications in permanent magnet synchronous machines (PMSMs). However, the zero-sequence current distortion increases the torque ripple and the overall power loss of the machine drive system. Besides, the common-mode voltage caused by the modulation strategy also impairs the lifespan and performance of both the converter and machine sides. Nonetheless, the combined suppression of zero-sequence current and common-mode voltage for series-end winding machine drives has not been reported until now. Thus, a spatial active zero-state-based space vector modulation (SVM) strategy is proposed in this article, where two spatial voltage vectors are selected to replace the zero-voltage vector. Moreover, a virtual voltage vector is established to cope with the high switching frequency in the proposed method, which makes the switching actions exactly the same as traditional 3-D SVM strategies and lower than the existing active zero-state-based SVM. The experimental results are carried out to verify the effectiveness of the proposed strategy, and it shows that comparable converter and machine common-mode voltages, better current distortion suppression effects, lower power loss of the converter, and higher machine efficiency can be realized compared with the existing active zero-state-based SVM strategy.
7 November 2025 in IEEE Transactions on Industrial Electronics
Owing to the integration of dc excitation and ac armature within one set of stator winding, zero-sequence current excited machines (ZSCEMs) have received growing research interests with distinct flux regulation capability via effective dc-biased sinusoidal (ac) current utilization instead of a redundant H-bridge excitation converter. In order to drive ZSCEM, a nine-switch converter is normally adopted. Nonetheless, the existing space vector modulation (SVM) strategies of nine-switch drive topology generally suffer from high switching frequency, unbalanced stress, and compromised efficiency. To this end, a novel 3-D SVM is proposed for nine-switch converter fed ZSCEM for effective reduction of switching frequency. Through establishing nine planes in ABC-coordinate, three nearest fundamental voltage vectors can be easily selected, which can effectively reduce the switching modes. Moreover, compared with the conventional schemes, the switching actions within one control period can be reduced by approximately 40% via purposely choosing a specific zero-voltage vector, which can improve the operational efficiency. Besides, it should be further highlighted that the switching actions for each power switch are more balanced, which is beneficial for the alleviation of heat stress and lifetime extension of power switches. Finally, the effectiveness of the proposed 3-D SVM strategy is validated by both simulation and experimental results.