11 May 2020 in IEEE/ASME Transactions on Mechatronics
Power management is a vital technology to increase the economy of fuel cell hybrid vehicles. To overcome the deficiency of most existing optimization approaches, a modified model predictive control-based optimal strategy of power management is proposed for fuel cell hybrid vehicles. Besides, a partial least squares-based load estimation method is utilized to avoid the assumption of conventional model predictive control. Furthermore, an alternating direction multiplier method-based quadratic programming solver is also designed to avoid the ill condition of the quadratic programming. Finally, the reliability and effectiveness of the proposed strategy are demonstrated by the simulation and experiments.
25 March 2019 in Asian Journal of Control
27 July 2022 in IEEE/ASME Transactions on Mechatronics
An optimal strategy for simultaneous charging of electric vehicle battery packs is proposed as a multiobjective optimization problem in this article. The charger consists of $\bm {n}$ constant voltage current sources for charging $\bm {n}$ batteries, respectively. Considering the energy loss and the charging criteria, a battery charging issue for the charging mode is formulated as a multiobjective optimization problem and the optimal solution is obtained with the application of quadratic programming. In addition, an adaptive momentum-based steepest descent algorithm is propounded to minimize the simultaneous charging time in the charging mode. Simulation and experimental results show that the actual state of charge converges to the same value within the theoretical shortest time for under the charging mode.
18 October 2010 in AIP Conference Proceedings
We consider Polydimethylsiloxane (PDMS) as a prospective structural material candidate for a Micro Fuel Cell. The introduction of such a polymer as structural material will reduce the mass and the size of the micro fuel cell and therefore optimize the current micro fuel cell models. In this perspective, our work focuses on the tailorability and optimization of thermal, mechanical bonding properties of PDMS with nano size carbon black particles as filler (PDMS‐CB). The wt% of the filler is varied from 10% to 25%. The mechanical property is characterized by testing the bond strength of the bond between pure PDMS and PDMS‐CB composite. The bond between pure PDMS and 10% carbon black filled PDMS broke at 0.72 MPa. The bond has become very strong for other samples with higher wt% (>10%). In this case the bond did not break but the break occurred on the pure PDMS side. The Thermal Gravimetric Analysis (TGA) study has shown good thermal stability of the composite up to 500 °C.
29 March 2022 in SAE International Journal of Advances and Current Practices in Mobility
Vehicle speeds, in both longitudinal and lateral directions, are vital signals for vehicular electronic control systems. In in-wheel motor-driven vehicles (IMDVs), because no slave wheel can be used for reference, it becomes more challenging to conduct velocity estimation, especially when all wheels turn to slip. To reduce the dependence of speed estimation on physical plant parameters and environment perception, in this work, we develop a new method that estimates the longitudinal and lateral velocities of an IMDV by using the kinematic model with the Kalman Filter. For longitudinal velocity measurement, we propose a hybrid approach combining Long-Short Term Memory (LSTM) networks and the kinematic rules to obtain a reliable estimation. More specifically, when at least one effective driven wheel is available, that is, no-slip happening, the longitudinal velocity can be derived using the average of those effective wheels' rotational speeds. When all driven wheels slip, the information of longitudinal velocity can be provided by the LSTM network. The previous longitudinal velocity is augmented in the input features to improve the learning accuracy of the estimation. Moreover, the cumulative errors caused by acceleration integration are avoided, and the precision is thus improved. Finally, hardware-in-the-loop (HiL) tests are carried out on dSPACE/SCALEXIO to verify the feasibility and effectiveness of the proposed method.