Low-temperature combustion has shown the potential to provide solutions for future clean and efficient powertrain systems. Traditional approaches using the first law of thermodynamics have been established for describing energy flows within engine systems and comparing losses between low-temperature and traditional combustion modes. An augmented approach, using the second law of thermodynamics, can be utilized to gain insight into the exergy flows within the system and thus identify areas of irreversibilities and inefficiencies. The present article aims at introducing the required framework for the second law analysis of low-temperature combustion concepts and demonstrating its application to boosted homogeneous charge compression ignition engines. The framework consists of a combination of the first law and second law expressions combined with the University of Michigan homogeneous charge compression ignition combustion model and was applied on a modeled light-duty four-cylinder boosted homogeneous charge compression ignition engine. It was found that combustion irreversibilities in homogeneous charge compression ignition were ∼25% more than traditional spark ignition or diesel engines and increased with dilution. On the other hand, exergy transfer to the walls was reduced with low-temperature combustion. It was also found that the combination of negative valve overlap and turbocharging is not beneficial for high-load operation. Exergy analysis of the exhaust system revealed that turbine useful work was lower than 50% of exergy at the exhaust ports and indicated that boosting performance may be improved by manipulating exergy transfer in the exhaust manifold. Results from the present study are focused on boosted homogeneous charge compression ignition, but the conclusions reached are applicable to other low-temperature combustion concepts as well.
This study discusses a novel approach toward homogeneous charge compression ignition operation in the 5 - 10 bar net indicated mean effective pressure range. This approach is based on the combination of boosting and variable valve actuation to maximize engine efficiency. Compression ratio plays a key role and determines low-temperature combustion feasibility in modern gasoline compression ignition concepts. In order to explore the interactions between compression ratio, boosting system and variable valve actuation, multi-cylinder engine models were utilized which employed the University of Michigan combustion model. Valve strategies featured switching from low-lift negative valve overlap to high-lift positive valve overlap, and the switching point was found to be dependent on compression ratio. A recent study by the authors suggested that heating the charge from external compression is more efficient than heating by residual gas retention strategies. Use of non-cooled intake air allows for valve events and combustion phasing that promote turbocharger performance and alleviate the backpressure problems often associated with low temperature combustion engines. Elevated intake pressure and reduced pumping work allow for improvements in efficiency with minimal NOx formation and acceptable ringing. It was found that further efficiency benefits can be realized by increasing compression ratio. Identification of trade-offs between engine hardware and combustion mode appears to be critical for homogeneous charge compression ignition operation in the 5 -10 bar net indicated mean effective pressure range. By focusing on this operating range, the present modeling study attempts to shed some light on practical applications of light-duty gasoline compression ignition concepts.