Jilei Hou

Jilei Hou

Auto-generated profile, based on publicly available information

Jilei Hou

Hefei Institutes of Physical Science, Chinese Academy of Sciences, Hefei 230031, China

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 September 2021 in Nuclear Fusion
Verified
Journal Article
Closed access
PDF file
MJManni Jia
Manni Jia
ALAlberto Loarte
Alberto Loarte
YSYouwen Sun
Youwen Sun
QMQun Ma
Qun Ma
XWXuemin Wu
Xuemin Wu
GZGuizhong Zuo
Guizhong Zuo

17 June 2021 in Nuclear Fusion
Verified
Journal Article
Open access
PDF file
NYN. Yan
N. Yan
LCL. Chen
L. Chen
GXGuosheng Xu
Guosheng Xu
XWX.Q. Wu
X.Q. Wu
SLS.C. Liu
S.C. Liu
JLJ.B. Liu
J.B. Liu
Upstream density profiles in the scrape-off layer (SOL) have been examined in low-confinement mode (L-mode) and high-confinement mode (H-mode) plasmas in the EAST superconducting tokamak. A weak density shoulder forms in the near SOL region in upper single-null configurations when the neutral pressure measured at the lower divertor exceeds a threshold value of 2 × 10−2 Pa in L-mode plasmas. When the neutral pressure is below this threshold, the weak density shoulder is absent and the sidebands of the lower hybrid waves associated with SOL parametric instabilities are reduced. Active detachment control with neon–deuterium seeding demonstrate that the weak density shoulder can form before the onset of the outer divertor detachment as long as the neutral pressure is above the threshold. Furthermore, no remarkable expansion of a shoulder is observed during divertor detachment, suggesting that divertor detachment is not a necessary condition for the formation or growth of a density shoulder. Through the increase in neutral pressure in the lower divertor by an order of magnitude, the weak shoulder was observed to expand into the far SOL and reach the leading edge of the limiter. The results in L-mode discharges identified the neutral pressure in the lower divertor as a primary factor for the formation of an SOL density shoulder in the upper single-null discharges. For the type-I ELMy H-mode plasmas, a similar density shoulder was detected during the inter-ELM phase when the neutral pressure in the lower divertor exceeded a threshold value of 4 × 10−2 Pa. On the other hand, the shoulder was absent when the divertor neutral pressure went below this threshold even though the plasma discharge was conducted with a higher core line-averaged density and divertor collisionality. This is consistent with the observations in L-mode plasmas. The neutral particle ionization of the working gas is thus believed to play a key role during the formation of the SOL density shoulder in the EAST tokamak.

29 August 2023 in Nuclear Fusion
Verified
Journal Article
Open access
PDF file
JYJingsheng Yuan
Jingsheng Yuan
GZGuizhong Zuo
Guizhong Zuo
SZShengbo Zhao
Shengbo Zhao
LLL. Li
L. Li
HZHuidong Zhuang
Huidong Zhuang
JHJiansheng Hu
Jiansheng Hu
Disruption mitigation poses a significant and unresolved challenge for ITER and future fusion reactor devices. To mitigate the effect of plasma disruption, a Shattered Pellet Injection (SPI) system has been developed and the first rapid shutdown experiments have been successfully performed in the Experimental Advanced Superconducting Tokamak with full metal wall. The experiments confirmed the system’s capability to inject 5 mm diameter neon (Ne) pellets at velocities ranging from 100 to 400 m s−1, with a maximum injected quantity of 13.2 Pa m3. Compared to unmitigated disruptions, the total radiation power was significantly higher with the respective use of SPI and Massive Gas Injection (MGI). Additionally, the radiation distribution and divertor heat flux were compared between SPI and MGI methods. The results demonstrated that SPI exhibited shorter cooling time, stronger core radiation and more uniform poloidal radiation distribution compared to MGI, indicating deeper deposition using SPI. Furthermore, during plasma shutdown, the electron temperature and peak heat flux near outer divertor strike points were reduced by 40% and 50% respectively, with SPI, in comparison to MGI. These findings serve as a valuable reference for implementing SPI technology as the baseline approach for disruption mitigation in ITER.

2 August 2019 in Nuclear Fusion
Verified
Journal Article
Closed access
PDF file
JHJilei Hou
Jilei Hou
JHJiansheng Hu
Jiansheng Hu
YCYue Chen
Yue Chen
YSYouwen Sun
Youwen Sun
YWYumin Wang
Yumin Wang
TTthe EAST Team
the EAST Team

1 August 2019 in Fusion Engineering and Design
Verified
Journal Article
Closed access
JHJilei Hou
Jilei Hou
JHJiansheng Hu
Jiansheng Hu
YCYue Chen
Yue Chen
YWYumin Wang
Yumin Wang
QZQing Zang
Qing Zang
JLJiangang Li
Jiangang Li

9 December 2023 in Results in Physics
Verified
Journal Article
Open access
JHJilei Hou
Jilei Hou
NYNing Yan
Ning Yan
QYQingquan Yang
Qingquan Yang
GZGuizhong Zuo
Guizhong Zuo
JHJiansheng Hu
Jiansheng Hu
XYXiaolin Yuan
Xiaolin Yuan
In metal-wall EAST superconducting tokamak, H-mode operation with plasma density close to the Greenwald density limit nGW has been achieved with radio frequency and NBI heating for the first time. Both gas puffing from horizontal plane and HFS pellet fueling were used for density ramp-up during the experiment. The confinement of H-mode gradually deteriorates with plasma density increasing. And the H-L transition can be observed after heating power dropping or pellet injection. In the density range of (0.6–1)×nGW, the divertor detachment occurs and causes an obvious confinement degradation. The maximum accessible density ne, max in H-mode phase deviates from the Greenwald scaling. It has been observed that the fraction ne, max/nGW is almost independent of the total heating power, but a high heating power is helpful to extend the duration of high density H-mode. And ne,max/nGW has an increase relation with the safety factor q95 varied by changing plasma current. Besides, it is also found that the discharges with low plasma current have a higher ne, max/nGW than those with high plasma current. All these findings will provide a good reference to the high density plasma operation for future metal-wall fusion devices.