1 June 2025 in Scientific Journal of Silesian University of Technology. Series Transport
Dynamic numerical stress analysis of a crankshaft subjected to load at selected operational points of a diesel engine is presented in this paper. The calculations and the analyses were carried out for six values of engine rotational speed and for two temperature values of engine structural elements. At each operating point of the engine, the piston-crank system was loaded with maximal gas pressure force, and additionally, inertia forces resulting from rotational speed of the crankshaft were taken into consideration. The analysis was carried out to obtain the distribution of the stress and to indicate critical areas where concentration of the stress may occur. In addition, the analysis was extended to other operational factors, such as the determination of the natural frequency of vibrations and effects of maximal torque on torsion of the crankshaft.
15 September 2025 in Combustion Engines
This study proposes an extended model with ten degrees of freedom (10 DoF), developed using the Newton–Euler formalism. Analytical derivation of the mass matrix and the vector of right-hand sides enables a significant reduction in computation time by eliminating matrix operations. For comparison, another 10 DoF model based on the homogeneous and joint coordinate transformation method is also considered. The aim is to assess how the choice of modeling formalism affects both computational efficiency and the fidelity of real-world motion representation. All three models (3 DoF and both 10 DoF variants) were tested in simulations of an overtaking maneuver under varying weather conditions. The analysis focused on differences in steering angle trajectories and tracking errors. Additional evaluations included a lane-change maneuver and a 736-meter driving scenario. Results show that extended models provide improved accuracy and better capture of dynamic vehicle behavior. In particular, the Newton–Euler-based 10 DoF model offers significant computational advantages. The maximum observed difference in steering angle between models reached 2 degrees, attributed to the 3 DoF model’s simplified treatment of tire forces and lack of friction coefficient consideration. The proposed models show strong potential for implementation in motion planning for autonomous vehicles.