1 February 2004 in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
We review in this paper our recent results on the correlation between the structural and the optoelectronic properties of Si nanocrystals (Si-nc) embedded in SiO2. We describe as well the development of both materials and technology approaches that have allowed us to successfully produce efficient and reliable LEDs by using only CMOS processes. Si-nc were synthesised in SiO2 by ion implantation plus annealing and display average diameters from 2.5 to 6 nm, as measured by electron microscopy. By varying the annealing time in a large scale we have been able to track the nucleation, pure growth and Ostwald ripening stages of the nanocrystal population. The most efficient structures have Si-ncs with average size of 3 nm and densities of about 1019 cm−3. We have estimated band-gap energies, lifetimes (20–200 μs) and absorption cross-sections (10−15–10−16 cm2) as a function of size and surface passivation. Based on these results, we propose a mechanism for exciton recombination based on the strong coupling of excitons with the heterointerfaces. From highly luminescent Si-nc, LEDs consisting of MOS capacitors were fabricated. Stable red electroluminescence has been obtained at room temperature and the I–V characteristics prove that the current is related to a pure tunnelling process. Fowler–Nordheim injection is not observed during light emission for electric fields below 5 MV/cm. Thus, hot carrier injection is avoided and efficient and reliable devices are obtained.
16 October 2006 in Applied Physics Letters
Si excess, Er content, and processing parameters have been optimized in a series of cosputtered oxide layers for maximizing Er emission and lifetime. The amount of excited Er as a function of the incident photon flux has been quantified for resonant and nonresonant excitations. Results show that a maximum of 3.5% of Er ions is excitable through the Si nanoclusters (Si-nc). This low value cannot be explained only by cooperative upconversion and/or excited state absorption. A short range distance dependent interaction model is developed that accounts for this low Er population inversion. The model points to the low density of Si-nc as the ultimate limiting step for indirect Er excitation in this system.
25 May 2011 in Discover Nano
This study investigates the influence of the film thickness on the silicon-excess-mediated sensitization of Erbium ions in Si-rich silica. The Er3+ photoluminescence at 1.5 μm, normalized to the film thickness, was found five times larger for films 1 μm-thick than that from 50-nm-thick films intended for electrically driven devices. The origin of this difference is shared by changes in the local density of optical states and depth-dependent interferences, and by limited formation of Si-based sensitizers in "thin" films, probably because of the prevailing high stress. More Si excess has significantly increased the emission from "thin" films, up to ten times. This paves the way to the realization of highly efficient electrically excited devices.
1 May 2017 in Journal of Luminescence
MSMaria I. Sánchez-Aniorte
+5
A transparent and conducting ZnO:Er:Yb thin film with upconversion properties has been achieved after being annealed with continuous laser radiation just before the ablation point of the material. This work demonstrates that the laser energy preserves the conductivity of the film and at the same time creates an adequate surrounding for Er and Yb to produce visible upconversion at 660, 560, 520, and 480 nm under 980 nm laser excitation. The relation between the structural, electrical and upconversion properties is discussed. It is observed that the laser energy melts part of the material, which recrystallizes creating rare earth oxides and two different wurtzite structures, one with substitutional rare earths and oxygen vacancies (responsible for the conductivity) and the other without substitutional rare earth ions (responsible for the upconversion emission)