30 October 2017 in IEEE Transactions on Antennas and Propagation
MMMaria-Teresa Martinez-Ingles
Maria-Teresa Martinez-Ingles
This paper presents the design, low-temperature co-fired ceramics (LTCC) fabrication, and full experimental verification of novel dielectric flat lens antennas for future high data rate 5G wireless communication systems in the 60 GHz band. We introduce and practically completely evaluate and compare the performance of three different inhomogeneous gradient-index dielectric lenses with the effective parameters circularly and cylindrically distributed. These lenses, despite their planar profile antenna configuration, allow full 2-D beam scanning of high-gain radiation beams. A time-domain spectroscopy system is used to practically evaluate the permittivity profile achieved with the LTCC manufacturing process, obtaining very good results to confirm the viability of fabricating inhomogeneous flat lenses in a mass production technology. Then, the lenses performance is evaluated in terms of radiation pattern parameters, maximum gain, beam scanning, bandwidth performance, efficiencies, and impedance matching in the whole frequency band of interest. Finally, the performance of the three lenses is also experimentally evaluated and compared to a single omni-directional antenna and to a ten-element uniform linear array of omni-directional antennas in real 60 GHz wireless personal area network indoor line-of-sight (LOS) and obstructed-LOS environments, obtaining interesting and promising remarkable results in terms of measured received power and root-mean-square delay spread. At the end of this paper, an innovative switched-beam antenna array concept based on the presented cylindrically distributed effective parameters lens is also introduced and completely evaluated, confirming the potential applicability of the proposed antenna solution for future 5G wireless millimeter-wave communication system.
11 December 2015 in IEEE Transactions on Microwave Theory and Techniques
DSDaniel Sanchez-Escuderos
VBVicente E. Boria-Esbert
Recently, gap waveguides have been shown as a potential alternative to convenational waveguides in the millimeter-wave band. Until now, groove gap waveguide (GGW) has been studied through direct correspondence with rectangular waveguide with the same physical dimensions. However, there have been observed differences in the above cutoff propagation characteristics between these two waveguide types. Furthermore, the behavior of GGW below cutoff remains unknown. This work presents a discussion of both below and above cutoff propagation characteristics of GGW, and introduces a simple model that explains the observed GGW behavior and establishes well its propagation characteristics. Two thru-reflect-line calibration kits have been manufactured, and the measurements have good agreement with the proposed analysis model results.
26 January 2021 in IEEE Antennas and Wireless Propagation Letters
This letter presents a 4 × 4 single-layer dual-band array antenna operating in the K- and Ka-band using gap waveguide (GW) technology. Radiating elements consist of I-shaped slots located on the top plate of the antenna and backed by a novel coaxial cavity with the dual-frequency operation. The antenna presents two ports, one for each band, and radiates a directive far field pattern with linear polarization. A single-layer wideband corporate-feed network is used to excite the cavities. In addition, a diplexer is integrated as part of the network to separate both working bands. Experimental results show impedance and radiation pattern bandwidths larger than 2 GHz in both bands.
8 January 2015 in IEEE Antennas and Wireless Propagation Letters
DNDiana V. Navarro-Mendez
MFMiguel Ferrando-Bataller
+1
A novel compact broadband monopole antenna inspired by a Vivaldi antenna is presented. In order to get a compact solution, the profile of a slot Vivaldi antenna has been modified and a wideband antenna covering LTE700, GSM850, GSM900, DCS1800, PCS1900, WCDMA2100, Bluetooth, WiMAX2350, WLAN2400, and LTE2600 standards has been obtained, with a size reduction length of 30% over conventional λ/4 monopole antennas. In contrast to traditional designs using Vivaldi antennas, a compact design with omnidirectional radiation pattern is proposed. Simulated and measured results are provided, which verify the broadband behavior of the antenna. In addition, the proposed design is perpendicularly mounted to a ground plane, being then suitable for mobile communications in vehicular applications.