This work investigates the root cause of failure with the ultimate anode, Li metal, when employing conventional/composite separators and/or porous anodes. Then a feasible route of utilizing Li metal is presented. Our operando and microscopy studies have unveiled that Li+ flux passing through the conventional separator is not uniform, resulting in preferential Li plating/stripping. Porous anodes alone are subject to clogging with moderate- or high-loading cathodes. Here we discovered it is necessary to seek synergy from our separator and anode pair to deliver delocalized Li+ to the anode and then uniformly plate Li metal over the large surface areas of the porous anode. Our polymer composite separator containing a solid-state electrolyte (SE) can provide numerous Li+ passages through the percolated SE and pore networks. Our finite element analysis and comparative tests disclosed the synergy between the homogeneous Li+ flux and current density reduction on the anode. Our composite separators have induced compact and uniform Li plating with robust inorganic-rich solid electrolyte interphase layers. The porous anode decreased the nucleation overpotential and interfacial contact impedance during Li plating. Full cell tests with LiFePO4 and Li[Ni0.8Mn0.1Co0.1]O2 (NMC811) exhibited remarkable cycling behaviors: ∼80% capacity retention at the 750th and 235th cycle, respectively. A high-loading NMC811 (4 mAh cm-2) full cell displayed maximum cell-level energy densities of 334 Wh kg-1 and 783 Wh L-1. This work proposes a solution for raising energy density by adopting Li metal, which could be a viable option considering only incremental advancement in conventional cathodes lately.
We fabricated nanowires of a conjugated oligomer and applied them to organic field-effect transistors (OFETs). The supramolecular assemblies of a thienoisoindigo-based small molecular organic semiconductor (TIIG-Bz) were prepared by co-precipitation with 2-bromobenzaldehyde (2-BBA) via a combination of halogen bonding (XB) between the bromide in 2-BBA and electron-donor groups in TIIG-Bz, and chalcogen bonding (CB) between the aldehyde in 2-BBA and sulfur in TIIG-Bz. It was found that 2-BBA could be incorporated into the conjugated planes of TIIG-Bz via XB and CB pairs, thereby increasing the π − π stacking area between the conjugated planes. As a result, the driving force for one-dimensional growth of the supramolecular assemblies via π − π stacking was significantly enhanced. TIIG-Bz/2-BBA nanowires were used to fabricate OFETs, showing significantly enhanced charge transfer mobility compared to OFETs based on pure TIIG-Bz thin films and nanowires, which demonstrates the benefit of nanowire fabrication using 2-BBA.