1 August 2016 in Applied Thermal Engineering
18 April 2012 in Discover Nano
The surface tension of ethanol and n-decane based nanofluid fuels containing suspended aluminum (Al), aluminum oxide (Al2O3), and boron (B) nanoparticles as well as dispersible multi-wall carbon nanotubes (MWCNTs) were measured using the pendant drop method by solving the Young-Laplace equation. The effects of nanoparticle concentration, size and the presence of a dispersing agent (surfactant) on surface tension were determined. The results show that surface tension increases both with particle concentration (above a critical concentration) and particle size for all cases. This is because the Van der Waals force between particles at the liquid/gas interface increases surface free energy and thus increases surface tension. At low particle concentrations, however, addition of particles has little influence on surface tension because of the large distance between particles. An exception is when a surfactant was used or when (MWCNTs) was involved. For such cases, the surface tension decreases compared to the pure base fluid. The hypothesis is the polymer groups attached to (MWCNTs) and the surfactant layer between a particle and the surround fluid increases the electrostatic force between particles and thus reduce surface energy and surface tension.
1 January 2015 in Journal of Propulsion and Power
A droplet stream combustion experiment was developed to understand the effect of reducing droplet size to a micrometer scale on the combustion characteristics of nanofluid fuels, which are liquid fuels with a stable suspension of nanoparticles. Pure ethanol and ethanol with aluminum nanoparticles at varying concentrations (up to 5 wt%) and droplet sizes were studied. The effect of particle addition on the droplet-burning rate was determined, and the mechanisms that are responsible for that effect were identified. The results show that the droplet-burning rate increases with increasing particle concentration. For example, with a 5 wt% addition of 80 nm aluminum nanoparticles, the burning rate increased by 140%. The burning rate enhancement is mainly attributed to strong radiation absorption of the nanoparticles suspended within the droplets, which provides more energy from the exothermic reaction (the flame) to the liquid phase (the droplets) for vaporization, thus increasing the burning rate. The radiatio...
1 April 2016 in Combustion and Flame
2 July 2015 in Journal of Applied Physics
This paper reports measured and calculated (through molecular dynamics simulations) latent heat of vaporization (Hfg) for water and ethanol based nanofluids. The experimental results showed that the addition of 3 wt. % Ag and Fe nanoparticles in water results in a substantial reduction in Hfg (25% and 17%, respectively). On the contrary, 3 wt. % Al addition slightly increases Hfg (3%). Similar trends were observed for ethanol based nanofluids: 3 wt. % addition of Ag and Fe resulted in a reduction in Hfg by 19% and 13%, respectively, whereas 3 wt. % Al addition resulted in an increases in Hfg by 2%. Molecular dynamics simulations, which determine Hfg by calculating the total enthalpy change of a system before and after vaporization from a molecular level, showed that the strength of bonding between the nanoparticles and the fluid molecules is the governing factor in the variation of Hfg upon particle addition. It was found that the strength of Al/water bonds was much greater than Ag/water, resulting in a reduction in Hfg for the Ag/water nanofluids.