1 March 2012 in Construction and Building Materials
5 March 2014 in Smart Materials and Structures
1 December 2012 in Construction and Building Materials
1 January 2012 in Transportation Research Record: Journal of the Transportation Research Board
Despite a large body of research on operating speeds, there is still much to learn about the factors that affect free-flow speeds, especially with regard to the development of a continuous speed profile for two-lane rural highways. This paper presents a new approach to modeling driver speed profile along two-lane rural roads. Speed data regarding individual drivers traveling on selected two-lane rural roads were sampled during a naturalistic experiment that used an onboard Global Positioning System (GPS). GPS devices facilitate the collecting and processing of continuous speed data. Unlike spot speed measurements, which have typically been collected in similar studies, continuous speed data are useful for studying the actual speed profile with regard to acceleration–deceleration behavior and maximum speed on tangents and curves. New variables are used in the regression equation. These variables refer to the horizontal curvature and the vertical grade as weighted values of the geometric features of the alignment preceding and following the vehicle position. To predict the operating speed, the model takes into account the geometric alignment of the road preceding and following the vehicle, as this information is used by drivers to establish the driving task, which is based on memory expectation, vehicle dynamics, and visual perception. The final result is an algorithm for modeling a continuous speed profile without previous assumption of acceleration–deceleration rate and constant speed on tangents and curves.
30 July 2014 in Road Materials and Pavement Design
The present paper reports the results of a laboratory investigation aimed to investigate the resilient behaviour of unbound granular materials (UGMs) for pavement unbound layers under repeated triaxial loading. The first part of research was focused on the effects of stress history, in terms of loading conditioning phase and stress paths, on the resilient response of the investigated UGM. The obtained results highlighted that the samples that experienced several stress paths after an initial stress conditioning showed reduced resilient moduli as well as higher stress dependency of the resilient properties as compared with samples not subjected to any specific stress history. The second part of research aimed to evaluate the influence of the conditioning stress level on the resilient modulus. The results showed poorer resilient characteristics along the several stress paths as the selected conditioning stress increases. Whereas, a sort of “loading memory effect”, resulting in a similar mechanical behaviour, can be recognised as a similar stress state between conditioning phase and subsequent stress path is considered. The study confirms the high dependency of the resilient response of UGM on the stress condition and in particular, the main role of conditioning confining pressure on the stable mechanical behaviour of these materials is highlighted. Finally, a simplified approach that would allow the intrinsic resilient properties of UGM to be predicted for a specific combination of conditioning stresses and stress paths is proposed.