This study shows that modular multilevel converter (MMC) can implement deadbeat control and harmonic elimination together. MMC, under single‐phase deadbeat control, tracks the current reference exclusively, so that it is: (i) safe from large destructive currents of ac faults; and (ii) free from the odd harmonics generated by the non‐linearities of MMC. As a deadbeat control cannot filter even harmonics on the dc‐side, harmonic elimination has to be done by joint feedback–feedforward methods. However, the cost saving from capacitor size reduction, made possible by the harmonic elimination, comes to naught when large ac fault currents charge the capacitors to voltage levels destructive to insulated‐gate bipolar transistors. Deadbeat, in preventing the flow of large fault currents, safeguards capacitor size reduction made possible by the harmonic elimination methods. Redundant protection by the methods enhances reliability. Claims are validated by simulations by SIMULINK of MATLAB.
The surface pre-treatment is of great significance for improving the welding quality of metal materials, especially aluminum alloys. At present, the welding process is introduced to achieve the joining of the selective laser melting (SLM) AlSi10Mg alloys or their repair during manufacturing or service. However, the high susceptibility of hydrogen pores is one of the most important problems encountered in the fusion welding process of SLM AlSi10Mg alloys. To clarify the influence of the surface state of the base metal on the hydrogen pore characteristics, the SLM AlSi10Mg alloys sheets were pretreated by chemical cleaning treatment (CCT), mechanical polishing treatment (MPT) and chemical cleaning after mechanical polishing (MPT-CCT) before autogenous laser welding. Subsequently, the hydrogen pore characteristics, microstructure and micro-hardness of the weld joints were investigated. The experimental results show that the autogenous laser welding with MPT-CCT pre-treatment conspicuously reduces the porosity and pore diameter. In addition, TEM results show that MPT-CCT pre-treatment can eliminate most of the broken and discontinuous surface oxide film and Mg enrichment. In summary, the necessity of MPT-CCT surface pre-treatment for SLM aluminum alloy parts is analyzed systematically, which is of great significance to improve the welding quality.