12 February 2021 in IEEE Transactions on Electron Devices
Effects of low-temperature annealing in nitrogen atmosphere on elevated-metal metal-oxide (EMMO) thin-film transistors (TFTs) are investigated and reported in this article. Compared with the short-circuit behavior of EMMO TFTs after annealing in nitrogen atmosphere at 300 °C, it is found that TFTs received annealing in nitrogen atmosphere at 200 °C prior to that at 300 °C not only remain the transfer characteristics, but also exhibit improved on-state current and subthreshold characteristics. Both the results of X-ray photoelectron spectroscopy (XPS) and persistent photoconductivity (PPC) confirmed the reduction of oxygen vacancies in the a-IGZO after annealing in nitrogen atmosphere at 200 °C, indicating that the passivation of oxygen vacancy with nitrogen is dominant rather than the generation of oxygen vacancy. Furthermore, the thermal stability improvement could not be realized when the annealing in nitrogen atmosphere at 200 °C was performed before the source/drain formation annealing at 400 °C, which emphasizes the importance of annealing procedures during device fabrication.
20 August 2021 in IEEE Electron Device Letters
In this letter, the carrier mobility of amorphous InGaZnO (a-IGZO) thin-film transistor (TFT) was remarkably enhanced by the introduction of nitrogen and the formation of Zn 3 N 2 , in which the saturation field-effect mobility ( $\mu _{\text {sat}}$ ) was 61.6 cm 2 /Vs. Annealing temperature plays a key role on the enhancement of carrier mobility. When the annealing temperature was increased to 400 °C, $\mu _{\text {sat}}$ was reduced to 4.1 cm 2 /Vs, which was proposed to be due to the formation of defective Zn x N y based on X-ray photoelectron spectroscopy results. In addition, the a-IGZO TFT with enhanced mobility did not exhibit persistent photoconductivity behavior. The high carrier mobility could expand the application of a-IGZO TFTs to functional circuits in active-matrix displays.
27 May 2020 in IEEE Transactions on Electron Devices
Characteristics of amorphous indium-gallium-zinc oxide (a-IGZO) thin-film transistors (TFTs) are highly dependent on the hydrogen (H) content within the device architecture, for example in the etch-stop layer (ESL) of the elevated-metal metal-oxide (EMMO) TFTs. The serious apparent ``short-channel effect (SCE)'' was caused by the H diffusion from source/drain (S/D) to channel. Such SCE deterioration can be suppressed by thermal dehydrogenation at a cost of long annealing time, especially for a transistor architecture with a-IGZO S/D covered with H-rich silicon nitride (SiNₓ:H) and further capped with metallic H-diffusion barrier. The dehydrogenation efficiency is found to be significantly enhanced by fluorinating the a-IGZO. By optimizing the device architecture and/or the fluorination process to enhance the dehydrogenation, the SCE can be efficiently eliminated with well-maintained performance even for 2 μm-long a-IGZO TFTs.
10 June 2022 in IEEE Transactions on Electron Devices
Nitrogen doping is introduced in elevated-metal metal-oxide (EMMO) thin-film transistors (TFTs) by sputtering amorphous indium gallium zinc oxide (a-IGZO) channel in Ar and N 2 gas mixture. The electrical characteristic and reliability of TFTs under negative/positive bias illumination stress (N/PBIS) are systematically investigated on TFTs of different channel lengths ( ${L}\text{s}$ ). Compared with undoped TFTs, the short-channel effect (SCE) of the N-doped TFTs is significantly suppressed, the persistent photoconductivity (PPC) effect is weakened, and N/PBIS reliability is largely improved. Short- and long-channel N-doped TFTs have about the same reliability performance. X-ray photoelectron spectroscopy (XPS) analysis shows that N-doping forms Zn=N bonds in the channel and oxygen vacancies ( ${V}_{O}$ ) are reduced. Based on a group of TFTs with different ${L}\text{s}$ , channel mobility ( $\mu _{{\mathrm {ch}}}$ ) and source–drain series resistance ( ${R}_{{\mathrm {sd}}}$ ) are correctly extracted. In N-doped TFTs, $\mu _{{\mathrm {ch}}}$ has a limited decrease owing to the increase in ${R}_{{\mathrm {sd}}}$ . N-doped TFTs with different Ar/N 2 gas-flow ratios show similar electrical and reliability performance, indicating a wide process window.
10 January 2025 in IEEE Electron Device Letters
Negative bias illumination stress (NBIS) instability is an important issue to overcome for the application of amorphous InGaZnO4 (a-IGZO) thin-film transistors (TFTs) in flat-panel displays. In this work, TFTs based on praseodymium (Pr)-doped a-IGZO were fabricated, and their NBIS stability at different temperatures was characterized. The transfer curve shifts in the negative gate bias direction under NBIS, and the magnitude of the shift increases significantly at elevated temperatures even with a weak illumination intensity. Benefiting from Pr doping, the oxygen vacancies in the channel a-IGZO can be reduced for TFTs with a metal cover layer after annealing in an oxygen atmosphere. Thus, significantly improved NBIS stability of a-IGZO TFTs at both room temperature and elevated temperatures is demonstrated.
16 October 2025 in IEEE Journal of the Electron Devices Society
Negative bias illumination stress (NBIS) instability presents a significant challenge for the application of amorphous InGaZnO4 (a-IGZO) thin-film transistors (TFTs) in active-matrix displays. In this paper, we demonstrate the effectiveness of incorporating split metal lines to enhance the NBIS stability with elevated-metal metal-oxide (EMMO) a-IGZO TFTs. The negative shift in subthreshold current after NBIS is successfully reduced from 3.92 V to 0.54 V when the width of the metal line reaches 2.0 lm, which is now predominantly caused by negative gate bias induced redistribution of pre-existing ionized oxygen vacancies in the channel a-IGZO. The enhanced NBIS stability is achieved through the illumination shielding effect by the metal lines and passivation of oxygen vacancies under the metal lines by oxygen laterally diffused from the spacing regions between the metal lines. The less degraded a-IGZO regions under the metal lines determined the overall performance of the a-IGZO TFT after NBIS.