9 September 2020 in IEEE Transactions on Magnetics
For high speed motors, smaller rotor diameters are required to make the surface speed less than 250 m/s. At the same time, dynamo motors for propulsion systems often require high torque. In such an environment, permanent magnet synchronous motors are more suitable than induction motors. In this work, a 270 kW dynamo motor is designed with a Halbach array using samarium-cobalt permanent magnets. It utilizes the rotor back iron and carbon fiber sleeve on the rotor surface. Two design goals are set when the rotor inner and outer radii are fixed preferentially: minimization of PM usage and maximization of airgap field. A magnetic equivalent circuit is utilized to identify the saturation level of the rotor back iron and airgap field density. The Levenberg-Marquardt algorithm is applied to find the optimal coverage of radial magnet in a pole pitch and the optimal PM height. It is also observed that the resulting Halbach array motor is superior to surface-mounted permanent magnet motor in torque performance when the same amount of PM is used. A prototype motor was built on a real scale, but with a reduced stack length.
25 August 2020 in IEEE Transactions on Magnetics
Hybrid subdomain analysis is utilized to optimize the design of a high speed compressor motor. Permanent magnets (PMs) are arranged in Halbach array, and bounded by a carbon fiber sleeve. The stator core does not have a slot structure, so that it is advantageous in reducing the iron loss. Since the core saturation takes place, magnetic equivalent circuit (MEC) is used to find the permeability depending on flux density of stator yoke. Furthermore, since the core is not infinitely permeable in subdomain analysis, the solution is obtained in the whole subdomain regions: shaft, PM, air-gap, coil, and stator yoke. The results of hybrid analysis are compared with those of finite-element analysis (FEA). Very close matching results are obtained in flux density and torque even under yoke saturation. The stator yoke height is optimized against the rotor outer radius so that torque, power density and efficiency are maximized, while stator outer radius, stack length and coil area are fixed.