8 April 2024 in Applied Physics Letters
In this Letter, we investigated the electrostatic control capability and gate reliability of the BaTiO3 integrated AlGaN/GaN HEMTs. The fabricated HEMT exhibits a high peak maximum transconductance of 141 mS/mm, a large ON/OFF current ratio of 4.1 × 109, and a small subthreshold swing of 70.6 mV/dec, attributed to the gate leakage suppression and prominent gate coupling. These parameters demonstrate that the HEMT device with extreme permittivity BaTiO3 dielectric has the excellent electrostatic control capability. A high breakdown voltage of 1348 V was also achieved thanks to the screening of the negative gate image charges and the resulting improvement of electric field distribution by using double-layer BaTiO3 with the wrapped gate structure. Furthermore, gate bias step-stress and pulse I–V measurements show that the device exhibits a small VTH shift of 0.06 V at 2 V bias stress and a slight current collapse of ∼2.7% accompanied with a 6.0% RON increment at a quiescent drain bias VDSQ = 30 V, which benefits from the high quality of the dielectrics/AlGaN interface with Dit of 8.87 × 1012 eV−1/cm2. These findings elucidate the immense potential of extreme permittivity dielectrics engineering in achieving high-performance AlGaN/GaN power electronic devices.
11 August 2025 in Applied Physics Letters
In the letter, we demonstrate that the performance enhancement of normally-off AlGaN/GaN metal–oxide–semiconductor-high-electron-mobility transistors (MOS-HEMTs) benefits from the prominent dielectric polarization of extreme-k BaTiO3. The fabricated HEMTs exhibit a high threshold voltage of 1.67 V, attributed to the additional negative polarization bound charges at the BaTiO3/AlGaN interface and the resulting expansion of depletion width under negative gate bias. A relatively large saturation output current of 374 mA/mm is also achieved thanks to the additional positive polarization bound charges and the resulting enhancement of channel electron concentration under positive gate bias. Further, the extremely high dielectric constant of BaTiO3 and the corresponding capacitive coupling effect enable a notable improvement in channel controllability, achieving a high maximum transconductance of 108.7 mS/mm and a small subthreshold swing of 69.6 mV/dec. The proposed BaTiO3-MOS-HEMTs with fine post-etch treatments also exhibit low gate leakage, a competitive breakdown field of 1.4 MV/cm, and a high Baliga's figure-of-merit of 1.05 GW/cm2. These findings elucidate the substantial potential of extreme-k BaTiO3 for high-performance normally-off AlGaN/GaN power switching applications.
21 July 2025 in Applied Physics Letters
This work investigated impedance-dependent degradation mechanisms in GaN high-electron-mobility transistors (HEMTs) under high-voltage radio frequency (RF) stress, focusing on electro-thermal coupling and trap evolution. In devices with matched impedance, slight degradation in output power (Pout), saturated drain current (Idss), and transconductance (GM) is observed after RF stress. This is attributed to an increase in trap density within the AlGaN layer and at the AlGaN/GaN interface, as evidenced by low-frequency noise results. In contrast, severe degradation in Pout, Idss, GM, and gate leakage current (IG) occurs in those devices with the 50-Ω mismatched impedance condition. Anyway, these more severe degradation effects result not only from the increased trap density after RF stress, but also primarily from the temperature rise caused by reflected power-induced Joule heating, as validated by infrared thermography. Electro-thermal simulations reveal dual lateral electric field peaks near gate edges in 50-Ω mismatched devices, redistributing peak temperature toward the source–gate region and intensifying localized Joule heating, thereby accelerating degradation. These findings highlight the critical role of impedance matching in GaN HEMT reliability, offering guidelines for designing robust power amplifiers in microwave systems.
9 December 2024 in Applied Physics Letters
This Letter demonstrates AlGaN/GaN high-electron-mobility transistors (HEMTs) with Hf0.5Zr0.5O2 (HZO) ferroelectric gate dielectric using pulsed laser deposition (PLD). An ultrathin Al2O3 interlayer grown by atomic layer deposition is used to avoid destroying the AlGaN surface and decreasing the electron density of a two-dimensional electron gas channel before PLD. The high-quality HZO on AlGaN/GaN heterostructure contributes to the good insulating and ferroelectric properties of the HZO film, yielding a superior ON/OFF current ratio of 4 × 1011 and a low sub-threshold slope (SS) of 53.2 mV/dec. Moreover, the electrical characteristics of the device are systematically investigated before and after gate poling. In combination with the analysis of schematic band diagrams, we found that ferroelectric polarization can effectively regulate the capture and release processes of channel electrons by Al2O3/AlGaN interface defects. These results show that HZO-based ferroelectric HEMTs have great potential for high frequency, low power consumption, and multi-functional devices.
24 February 2025 in Applied Physics Letters
The ideal combination of high sensitivity and fast response speed is crucial for advanced photodetectors. Herein, we present a normally-off, visible-blind ultraviolet (UV) AlGaN/GaN phototransistor featuring a fluorine-ion-implanted trench gate structure. This design effectively disrupts the conductive channel of the AlGaN/GaN heterostructure, drastically reducing the dark current to the magnitude of 0.1 pA. The trench structure enhances the localized electric field in the confined gate region, significantly improving UV detection sensitivity. Additionally, the finite electric field enhancement induced from fluorine ions (F− ions) accelerates the establishment of photogenerated electron channels. Consequently, the phototransistor exhibits ultrafast response speed, with rise and decay times of 1.5 and 6.7 μs, respectively, along with an exceptional specific detectivity of 3.45 × 1016 cm·Hz1/2 W−1. The detection of weak UV light reaches as low as 76.0 nW/cm2. This remarkable detection capability allows the device to perform high-fidelity single-pixel imaging and facilitates real-time UV communication. The proposed AlGaN/GaN phototransistor, characterized by a straightforward fabrication process and excellent photoresponse performance, presents enticing prospects for multiple performance compatible optoelectronic devices.