1 May 2018 in Physics of Plasmas
A fast edge turbulence suppression event has been simulated in the electrostatic version of the gyrokinetic particle-in-cell code XGC1 in a realistic diverted tokamak edge geometry under neutral particle recycling. The results show that the sequence of turbulent Reynolds stress followed by neoclassical ion orbit-loss driven together conspire to form the sustaining radial electric field shear and to quench turbulent transport just inside the last closed magnetic flux surface. The main suppression action is located in a thin radial layer around , where ψN is the normalized poloidal flux, with the time scale ms.
30 October 2019 in Nuclear Fusion
28 February 2018 in Nuclear Fusion
29 August 2024 in Nuclear Fusion
Recent results from MAST Upgrade are presented, emphasising understanding the capabilities of this new device and deepening understanding of key physics issues for the operation of ITER and the design of future fusion power plants. The impact of MHD instabilities on fast ion confinement have been studied, including the first observation of fast ion losses correlated with Compressional and Global Alfvén Eigenmodes. High-performance plasma scenarios have been developed by tailoring the early plasma current ramp phase to avoid internal reconnection events, resulting in a more monotonic q profile with low central shear. The impact of m/n = 3/2, 2/1 and 1/1 modes on thermal plasma confinement and rotation profiles has been quantified, and scenarios optimised to avoid them have transiently reached values of normalised beta approaching 4.2. In pedestal and ELM physics, a maximum pedestal top temperature of ∼350 eV has been achieved, exceeding the value achieved on MAST at similar heating power. Mitigation of type-I ELMs with n = 1 RMPs has been observed. Studies of plasma exhaust have concentrated on comparing conventional and Super-X divertor configurations, while X-point target, X-divertor and snowflake configurations have been developed and studied in parallel. In L-mode discharges, the separatrix density required to detach the outer divertors is approximately a factor 2 lower in the Super-X than the conventional configuration, in agreement with simulations. Detailed analysis of spectroscopy data from studies of the Super-X configuration reveal the importance of including plasma-molecule interactions and D2 Fulcher band emission to properly quantify the rates of ionisation, plasma-molecule interactions and volumetric recombination processes governing divertor detachment. In H-mode with conventional and Super-X configurations, the outer divertors are attached in the former and detached in the latter with no impact on core or pedestal confinement.
27 December 2023 in Journal of Plasma Physics
The properties of the edge ion-scale turbulence are studied using the beam emission spectroscopy (BES) diagnostic on MAST. Evidence of the formation of large-scale high-amplitude coherent structures, filamentary density blobs and holes, 2–4 cm inside the plasma separatrix is presented. Measurements of radial velocity and skewness of the density fluctuations indicate that density holes propagate radially inwards, with the skewness profile peaking at 7–10 cm inside the separatrix. Poloidal velocities of the density fluctuations measured using cross-correlation time delay estimation (CCTDE) are found to exhibit an intermittent behaviour. Zonal-flow analysis reveals the presence of poloidally symmetric coherent oscillations – low-frequency (LF) zonal flows and geodesic acoustic modes (GAM). Shearing rates of the observed zonal flows are found to be comparable to the turbulence decorrelation rate. The observed bursts in density-fluctuation power are followed by quiescent periods with a transient increase in the power of sheared flows. Three-wave interactions between broadband turbulence and a GAM are illustrated using the autobispectral technique. It is shown that the zonal flows and the density-fluctuation field are nonlinearly coupled and LF zonal flows mediate the energy transfer from high- to low-frequency density fluctuations.
1 July 2023 in Review of Scientific Instruments
Two image-based velocity-inference techniques, cross-correlation time-delay estimation (CCTDE) and dynamic time warping (DTW), were tested. These techniques are conventionally used in the study of plasma dynamics, but they can be applied to any data where features propagate across the image field-of-view. Differences between the techniques were investigated, which showed that the shortcomings of each technique are complemented well by the strengths of the other. Thus, the techniques should be used in conjunction with each other for optimal velocimetry. For ease of use, an example workflow that applies the results in this paper to experimental measurements is provided for both techniques. The findings were based on a thorough analysis of the uncertainties for both techniques. Specifically, the accuracy and precision associated with inferred velocity fields were systematically tested using synthetic data. Novel findings are presented that strongly improve the performance of both techniques, some of which are as follows: CCTDE was able to operate accurately under most conditions with an inference frequency as short as 1 per 32 frames, as opposed to the typical 1 per ≥256 frames used in the literature; an underlying pattern in CCTDE accuracy depending on the magnitude of the underlying velocity was found; spurious velocities due to the barber pole illusion can now be predicted prior to CCTDE velocimetry through a simple analysis; DTW was more robust against the barber pole illusion than CCTDE; DTW performance with sheared flows was tested; DTW was able to reliably infer accurate flow fields from data with as low as 8 × 8 spatial channels; and however, if the flow direction was unknown prior to DTW analysis, DTW could not reliably infer any velocities.