6 August 2024 in Superconductor Science and Technology
We report on the fabrication, structural, and electrical transport characterizations of superconducting nanowire arrays based on nano-laser direct writing (NLDW). The thermal excitation-induced micro/nano fabrication based on the interactions between NLDW and superconducting Nb films was experimentally analyzed and simulated. Experimentally, the arrays of superconducting nanowires have an area of 190 × 190 with a critical transition temperature Tc
of 7.8 K and a critical current density Jc
of 20.8 MA cm−2 at 4.0 K. The width and arrangement of the nanowires are precisely controlled, exhibiting a minimal loss of 0.6 K in Tc
and excellent Jc
after LDW. The width of superconducting nanowires could be further optimized by adjusting parameters such as laser power, irradiation gap, and delay of points. Compared with electron beam lithography and focused ion beam, to some extent, the nanowires fabrication process based on NLDW provides a more efficient and cost-effective path for fabricating large-area superconducting circuits and devices.
1 December 2024 in Nano Futures
We report the evolution of electric transport of Nb bridges based on nanoscale thermal effects created by nanolaser direct writing (NLDW) on Nb films. The laser–Nb-film interaction was investigated experimentally and by simulation. We demonstrate laser parameters such as irradiation power and interaction time to manipulate the electric transport of Nb bridges, such as the critical current and transition temperature, via simulation, which align with the electron probe microanalyzer results. Based on the optimized laser parameters, we realize the continual changes in current–voltage characteristics via increasing irradiation power. Furthermore, Nb bridges after laser irradiation show the oscillations of the critical current when we apply the coil current under a magnetic field that is perpendicular to the Nb bridges, which is similar to the Fraunhofer pattern in a Josephson junction under a magnetic field. In this case, NLDW shows the potential to manipulate electrical performances, which could be used to trim tri-layer junctions, tune shunt resistors, adjust critical currents or even induce a Josephson junction in situ by further shrinking of the laser spot.
2 September 2025 in Journal of Physics D: Applied Physics
We propose the fabrication of micro-superconducting quantum interference devices via nano laser direct writing (NLDW). A 20 nm thick Nb film with a critical transition temperature of 9.2 K was deposited on a silicon substrate by sputtering, and nanopatterning was performed with NLDW. After optimizing parameters such as the laser pulse width and power, we investigated the electrical performance of SQUIDs by varying the laser power between 245 mW and 270 mW in 5 mW steps. Experimentally, the voltage–flux (V–Φ) characteristics of micro SQUIDs exhibited typical periodic modulation, confirming the Josephson effect and magnetic flux quantization effect based on the NLDW process. The noise spectral density measurements of SQUID fabricated with laser power of 265 mW achieved a white noise level of 3 /Hz , demonstrating comparable flux noise sensitivity compared to electron beam and ion beam fabrication processes. Furthermore, the devices retained stable superconducting and electrical performance after 101 days, illustrating excellent long-term stability. To some extent, the NLDW shows the potential to perform micro-nanopatterning of superconducting devices efficiently and cost-effectively, as well as an avenue for conducting nanoscale thermal engineering on superconducting devices for basic science research.