Several space organizations have been planning to establish a permanent, manned base on the Moon in recent years. Such an installation demands a highly reliable electrical power system (EPS) to supply life support systems and scientific equipment and operate autonomously in a fully self-sufficient manner. This paper explores various technologies available for power generation, storage, and distribution for space microgrids on the Moon. Several factors affecting the cost and mass of the space missions are introduced and analysed to provide a comprehensive comparison among the available solutions. Besides, given the effect of base location on the design of a lunar electrical power system and the mission cost, various lunar sites are introduced and discussed. Finally, the control system requirements for the reliable and autonomous operation of space microgrids on the Moon are presented. The study is complemented by discussing promising future technological solutions that could be applied upon a lunar microgrid.
1 December 2021 in Solar Energy Materials and Solar Cells
An accurate model to represent the photovoltaic modules is essential to facilitate the efficient deployment of these systems in terms of design, analysis, and monitoring considerations. In this respect, this study proposes a new approach to improve the accuracy of the widely used five-parameter single-diode model. Two new physical equations are introduced to represent the series and shunt resistances, while the other parameters are represented by well established physical expressions. In the proposed model, most of the parameters are in terms of the cell temperature, irradiance, and datasheet values, while a few parameters need to be tuned. The model is compared with four well-known methodologies to extract the parameters of the single-diode and double-diode models. The simulation studies make use of the different I-V characteristics provided in the photovoltaics (PVs) datasheets, characteristics extracted from an outdoor module, as well as the ones simulated with the software PC1D. The results show an improved precision of the proposed model to estimate the power characteristics for a wide range of temperatures and irradiances, not only in the maximum power point but also in the whole range of voltages. Furthermore, the proposed physical model can be easily applied to other kind of studies where a physical meaning of the PV parameters is of great importance.