The purpose of this work is to develop an express method of evaluating the coefficient of internal friction and cohesive strength of molding material briquettes. Advantages and disadvantages of modern evaluation methods of internal friction parameters in particulates have been considered, and the need to improve them has been substantiated. An alternative method based on measuring the position of shear planes and the briquette cracking pressure in uniaxial compression strength tests has been proposed. The theoretical justification of the method has been provided, and examples of implementation have been given. The research results may be used in the process of educating students of technical specialties, as well as at research and design organizations.
The paper presents the results of experimental studies on abrasion resistance of Hardox 500 steel and 20MnCr5 steel subjected to thermo-chemical treatment. These types of steel are often used for agricultural or construction machinery. Abrasion tests were performed on a T-11 pin using a disc tester. The test conditions correspond to the wear caused by micro-grinding and grain-cutting using particles from the product as well as a result of abrasion produced by loose abrasive material created through the chipping of silica sand grains. The obtained results can be useful in the selection of materials for machine components.
The paper investigated the influence of the impact angle of a solid particle jet on the erosion wear of 38GSA and Hardox 500 steel. The basis of the analysis was the assumption of the existence of a correlation between mechanical properties of the material, represented by the work of deformation (P) determined from the stressstrain diagram (U). The impact angle of quartz sand particles (30, 60, and 90 °) was considered through the separation of kinetic energy of particles impacting the eroded surface perpendicularly and tangentially.
This article discusses the influence of the mechanical properties of contacting materials on gas abrasive wear of steels in sandblasting devices. Wear rate
The effect of the internal (interparticle) and external friction on the limiting state generation has been analyzed in terms of the shear-induced failure criterion of the surface layers in the compacted disperse materials. The proposed design scheme based on the Mohr-Coulomb combined diagram has made it possible to develop an original method and derive analytic dependences for determining the normal and tangential stresses in the interlayer shear sites along with the orientation angles of these sites. It has been shown that, with increasing coefficient of external friction, the pressure in the interlayer shear sites reduces until tensile stresses are generated. This is accompanied by the nucleation of the crack at a right angle close to the side surface perpendicular of the formed item.