Hong Lei

Hong Lei

Auto-generated profile, based on publicly available information

Hong Lei

College of Electronic and Information Engineering Nanjing University of Aeronautics and Astronautics Nanjing Jiangsu People's Republic of China

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 April 2017 in Bioinspiration & Biomimetics
Verified
Journal Article
Closed access
PDF file
AAAli Ahrari
Ali Ahrari
HLHong Lei
Hong Lei
MSMontassar Aidi Sharif
Montassar Aidi Sharif
Kalyanmoy DebKalyanmoy Deb
Kalyanmoy Deb
XTXiaobo Tan
Xiaobo Tan
Inspired by the lateral line of aquatic vertebrates, an artificial lateral line (ALL) system can localize and track an underwater moving object by analyzing the ambient flow caused by its motion. There are several studies on object detection, localization and tracking by ALL systems, but only a few have investigated the optimal design of the ALL system, the one that on average provides the highest characterization accuracy. Design optimization is particularly important because the uncertainties in the employed flow model and in sensor measurements deteriorate the reliability of sensing. This study investigates the optimal design of the ALL system in three-dimensional (3D) space for dipole source characterization. It highlights some challenges specific to the 3D setting and demonstrates the shortcomings of the designs in which all sensors and their sensing directions are in the same plane. As an alternative, it proposes two design concepts, called 'Offset Strategy' and 'Angle Strategy' to overcome these shortcomings. It investigates potentials of having a swarm of cooperative ALLs as well. It performs design optimization in the presence of sensor and model uncertainties and analyzes the trade-off between the number of sensors and characterization accuracy. The obtained solutions are analyzed to reveal their strategies in solving the problem efficiently. The dependency of the optimized solutions on the uncertainties is also demonstrated.

9 August 2017 in IET Power Electronics
Verified
Journal Article
Open access
PDF file
FHFeng Hong
Feng Hong
HLHong Lei
Hong Lei
BJBaojian Ji
Baojian Ji
LLLongchun Li
Longchun Li
SWSiyu Wang
Siyu Wang
A new buck inverter without shoot‐through problem is presented and analysed in this study. The traditional dual‐buck inverter has been proposed to solve the shoot‐through problem of bridge‐type inverters, eliminate the dead‐time effect and improve the reliability along with the conversion efficiency. However, the existing dual‐buck inverter is prone to result in the problem of circulation and low utilisation rate of input voltage in half‐bridge‐type inverters. Besides, two or even four inductors are needed in the traditional dual‐buck inverter configuration, which leads to a larger volume and weight. In this study, single inductor and single power are used in the proposed buck inverter topology. The operating circuit is equivalent to a buck circuit during each mode, and only one switch works in high‐frequency condition at any time. A 1‐kW prototype is established and tested in this study. The results of simulation and experiments verify the validity of the theoretical analysis, along with the good performance in situations where small size, high conversion efficiency and high stability are required.