Xin Wang

Xin Wang

Auto-generated profile, based on publicly available information

Xin Wang

School of Mechanical Engineering, Shenyang University, Shenyang 110044, China

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 September 2025 in Crystals
Verified
Journal Article
Open access
PDF file
PDPengyu Dai
Pengyu Dai
YZYu Zhang
Yu Zhang
XWXin Wang
Xin Wang
JYJiahang Yan
Jiahang Yan
ZLZhao Lin
Zhao Lin
XYXiaohong Yi
Xiaohong Yi
Al2O3-3% TiO2-xAl (x = 0, 20, 40, 60 wt.%) composite coatings were prepared on Q235 substrate by plasma spraying technology, and the effects of pure Al phase addition on the microstructure and wear properties of the coatings were compared and analyzed. The results show that a unique splash-like structure was formed on the surface of the coating, and this structure became more obvious with the increase in Al content. Cross-sectional analysis shows that the introduction of pure Al phase reduces the large pores and cracks in the coating, forming a slender band structure. XRD analysis shows that the addition of pure Al phase leads to a decrease in the diffraction peak intensity of α-Al2O3, while the diffraction peak intensity of Al phase and γ-Al2O3 gradually increases, especially in the coating with 40% Al content; the diffraction peak of γ-Al2O3 increases significantly. XPS analysis further confirms that with the increase in Al content, a new pure Al peak appears in the Al element spectrum, and the peaks of α-Al2O3 and γ-Al2O3 fluctuate. In addition, the porosity of the coating decreases first and then increases and then decreases again with the increase in Al content. The porosity of the coating with 60% Al content is the lowest, at only 5.14%. Microhardness test results show that with the increase in Al content, the microhardness of the coating gradually decreases, and the fracture morphology changes from brittle fracture to irregular fracture, with the appearance of pull-out areas, indicating that the pure Al phase effectively improves the brittleness of the coating. However, the friction and wear test results show that the friction coefficient of the coating increases with the increase in Al content. The pure Al2O3 coating has high hardness and excellent wear resistance, while the coating with 60% Al content has the highest friction coefficient and the most severe wear. Moreover, adhesive wear phenomena appear on the coating surface with high Al content.

23 May 2018 in AIP Conference Proceedings
Verified
Conference Paper
Closed access
PDF file
JDJinfu Du
Jinfu Du
XWXi Wang
Xi Wang
MXMin Xu
Min Xu
JMJin Mao
Jin Mao
XZXinglong Zhao
Xinglong Zhao
Nimonic super alloy are extensively used in the aerospace industry because of its unique properties. As they are quite costly and difficult to machine, the machining tool is easy to get worn. To solve the problem, an experiment was carried out on a numerical control slitting automatic lathe to analysis the tool wearing conditions and parts’ surface quality of nimonic super alloy GH2132 under different cutters. The selection of suitable cutter, reasonable cutting data and cutting speed is obtained and some conclusions are made. The excellent coating tool, compared with other hard alloy cutters, along with suitable cutting data will greatly improve the production efficiency and product quality, it can completely meet the process of nimonic super alloy GH2312.