Nowadays, the basic requirements of gear transmissions are not limited to resistance and reliability, but often include good efficiency and low vibration and noise emissions. This article investigates the role of tooth flank micro-geometry in fulfilling these needs. A non-linear finite element approach has been conceived and exploited to investigate in detail the influence of the shape of profile modifications (PMs) on transmission error, root stress, and contact pressure. In this approach, the contact between teeth flanks is handled by ABAQUS general purpose contact algorithm without introducing any simplification based on gear geometry peculiarities. The boundary conditions are defined so that it is possible to automatically run a sequence of static analyses. The numerical results are first assessed by comparison with experimental measurements and then a comparison of contact and bending stresses of the same gear with long linear and long circular PMs is presented and discussed. The results of these comparisons show that the optimal amount of PMs is not independent of PM shape; hence, the procedures used to design linear PMs cannot be directly applied to the design of non-linear PMs.
In the present paper a research programme aimed at investigating both the bending and contact fatigue properties of an austempered ductile iron applied to gears is presented, in order to determine reliable values of the limits, which take into account the influence of the production process, to be applied in the design of gearboxes. The bending fatigue tests are performed according to the single tooth fatigue approach and the pitting tests are performed with a back-to-back rig. Metallurgical analysis is performed on the failed specimens, in order to understand the origin and the propagation of the failures and to appreciate the influence of the micro-structure on the performances obtained.
25 November 2019 in Computer-Aided Design and Applications
Computer-Aided Design and Applications is an international journal on the applications of CAD and CAM. It publishes papers in the general domain of CAD plus in emerging fields like bio-CAD, nano-CAD, soft-CAD, garment-CAD, PLM, PDM, CAD data mining, CAD and the internet, CAD education, genetic algorithms and CAD engines. The journal is aimed at all developers and users of CAD technology to ptovide CAD solutions for various stages of design and manufacturing. The journal publishes all about Computer-Aided Design and Computer-Aided technologies.
The introduction of Additive Manufacturing (AM) is changing the way in which components and machines can be designed and manufactured. Within this context, designers are taking advantage of the possibilities of producing parts via the addition of material, defining strategies, and exploring alternative design or optimization solutions (i.e., nonviable using subtractive technologies) of critical parts (e.g., gears and shafts). However, a safe and effective design requires specific resistance data that, due to the intrinsic modernity of additive technologies, are not always present in the literature. This paper presents the results of an experimental campaign performed on gear-samples made by 17-4 PH and produced via Laser Powder Bed Fusion (PBF-LB/M). The tests were executed using the Single Tooth Bending Fatigue (STBF) approach on a mechanical pulsator. The fatigue limit was determined using two different statistical approaches according to Dixon and Little. The obtained data were compared to those reported in the ISO standard for steels of similar performance. Additional analyses, i.e., Scanning Electron Microscopy SEM, were carried out to provide a further insight of the behavior 17-4PH AM material and in order to investigate the presence of possible defects in the tested gears, responsible for the final failure.