3 March 2023 in Journal of Applied Physics
When a laser is focused on an underwater object, it experiences a large amount of pressure owing to the plasma confinement effect of water. A hemispherical bubble is generated on the surface of the object, and large pressure is generated when the bubble collapses. In this study, we conducted experiments using different laser energies to analyze the pressure–time histories associated with bubble contraction. The maximum pressure was 10%–40% of the laser ablation pressure, whereas the pressure pulse width was 5–10 times longer than the laser pulse width. Furthermore, the bubble motion could be adiabatically explained, except for the plasma interaction region. The results indicate that the pressure at which the bubble collapses does not depend on the maximum size of the generated bubble but depends on the energy of water vapor within the bubble.
1 March 2004 in Japanese Journal of Applied Physics
Hard X-ray pulses are generated by focusing a picosecond laser beam (25-ps, 1064 nm) on a copper target in air at an intensity of 3×1013 W/cm2. X-ray energy is measured using an X-ray charge-coupled device. The obtained spectrum consists of strong Kα and Kβ emissions and a weak continuum at an energy range of 4–10 keV. The photon numbers of the hard X-rays (4–10 keV) were estimated to be approximately 4000 photons/4πsr/pulse.
1 December 2023 in AIP Advances
Ultrahigh-energy density (UHED) states greater than 1 Gbar pressure are typically observed under extreme conditions, such as in the core of an inertial confinement fusion implosion. A novel alternative approach for generating volumetric UHED states is to use nanowire arrays irradiated with a femtosecond ultrahigh-intensity laser. In this paper, we present an experimental investigation on laser absorption and energy transport in nanowire arrays irradiated with a picosecond kilojoule petawatt laser. The laser–target interactions were studied by measuring the x-ray emission and escaping hot electrons from a bare Cu foil and a foil with a nanowire array grown on its surface. The measured Cu-Kα and He-α emissions from the nanowire array were higher than those from the flat foil. In addition, hot electrons observed from the front surface of the nanowire array were enhanced. On the other hand, despite the stronger Kα emission from the nanowire array and the enhancement of hot electrons escaping from the front surface of the nanowire array, the number of hot electrons observed from the rear side of the flat foil target was slightly lower than that of the flat foil. A comparison of the experimental results with the results of a two-dimensional particle-in-cell simulation code suggested that the magnetic fields generated around the periodic nanowire array trap hot electrons, improving the electron-to-target energy coupling and efficiently producing UHED states.
29 March 2012 in AIP Conference Proceedings
Flyer acceleration technique using high-power lasers has several advantages such as the achieved velocities higher than 10 km/s and non-contamination to the products generated by impacts. In this study, we show that a high-power laser can achieve impact velocities higher than 10 km/s up to 60 km/s using sheet flyers with a diameter of ~ 0.5 mm and a thickness of ~ 30 - 50 ìm and spherical projectiles with a diameter of 0.1 - 0.3 mm. We discuss the difference between sheet and spherical flyers in the energy transfer efficiency from laser energy to flyer kinetic energy.
17 June 2026 in Nuclear Fusion
High-repetition-rate target injection and precise steering of multiple laser beams are essential for realizing laser-driven inertial fusion energy (IFE) reactors. EX-Fusion Inc. has established a facility to demonstrate these capabilities for the Fast Ignition scheme named the EX-Fusion Continuous Operation Laser Reactor (XF-COLR). Laser beam tracking and illumination of a free-falling stainless steel ball with a diameter of 1 mm were carried out at 10 Hz using multiple nanosecond and femtosecond lasers. The system with real-time correction of beam positions continuously operated for up to 12 h under ambient conditions and for 2.5–3 min under vacuum. Tracking performance, evaluated as standard deviations for 1500 shots under vacuum conditions, reached 121–139 m in the horizontal direction and 63–121 m in the vertical direction. The expected uncertainty at the engagement point propagated from the sensors was approximately 157 m. To the best of our knowledge, this is the first demonstration of dynamic tracking of an injected target using multiple laser beams steered by mirrors at 10 Hz, providing a reference for the development of future IFE reactors.
1 January 2015 in Plasma and Fusion Research
We have investigated preformed plasma generation inside a cone on cone-in-shell targets for fast ignition scheme. We focused on the study of preformed plasma generation via irradiation by an implosion laser. In the GEKKO-XII laser system (Institute of Laser Engineering, Osaka University), a large fraction of laser energy is frequency-doubled to a 527 µm wavelength light with KDP crystals, but unconverted fundamental light (λ = 1.053 µm) is ultimately a possible heating source for the target. We measured the temperature at the inside tip of the cone in several experimental conditions to verify the effect of unconverted light. The experimental results indicated that the direct irradiation inside the cone with the unconverted fraction is the primary source of preheating effects. The results also suggest that preheating is suppressed by “long” cone targets whose sizes are typically larger than the focal points of incident unconverted light.