With the widespread utilization of renewable energy sources, the virtual synchronous generator (VSG) with self-synchronization grid-connection capability has received significant attention. As the core component for power conversion, IGBTs have been a focal point of research due to their susceptibility to failure, affecting reliability and lifespan. Existing studies have managed to control internal IGBT chip junction temperature and extend lifespan through appropriate active thermal control methods. However, these methods either alter the structure of the original IGBT module or fail to compensate for the degradation in power quality. Additionally, they neglect the impact of long-term thermal cycling induced by fundamental frequency current on periodic junction temperature fluctuations. Therefore, this paper proposes an active thermal control method for internal IGBTs in VSG based on switching frequency modulation. This method reduces the average junction temperature of the IGBT and additionally periodic junction temperature fluctuation to some extent. Finally, the proposed method is validated through simulation and experimentation. The experimental results prove the effectiveness of the proposed method.
12 January 2026 in IEEE Transactions on Industrial Electronics
As power converters advance, the demand for higher switching frequencies has grown significantly. Owing to their high-speed switching characteristics, SiC MOSFETs are poised for widespread adoption in next-generation power electronic converters. However, this capability also intensifies gate-drive crosstalk oscillations, which can severely compromise converter reliability. To address this issue, this article proposes a novel passive crosstalk suppression circuit that requires minimal additional components while offering the following advantages: it can be connected in parallel and integrated without modifying the topological structure and principle of the conventional drive circuit; it does not require additional active control; and the switching speed of the device is minimally affected. Finally, a prototype is constructed and tested in a double pulse experiment platform. The feasibility of the proposed crosstalk suppression circuit is successfully verified.
1 January 2026 in IEEE Transactions on Industry Applications