29 September 2016 in IEEE Journal of Solid-State Circuits
Implementation of highly integrated optical receivers in CMOS promises low cost, but combining high gain, low noise, high bandwidth, and low power in a CMOS transimpedance amplifier is a challenge. Fortunately, the sensitivity of an optical receiver is improved by limiting its frontend bandwidth far below the symbol rate and using equalization to eliminate the resulting intersymbol interference (ISI). Analysis reveals that when using a decision-feedback equalizer (DFE) to cancel all postcursor ISI, receiver sensitivity is optimized by taking a front-end bandwidth as low as 0.12 fbit, depending upon the frequency response and noise spectrum assumed for the front end. This paper presents a 20 Gb/s optical receiver with a front-end bandwidth of 3 GHz. The front end is designed to have an approximately first-order response, ensuring only postcursor ISI, which may be efficiently canceled with a first-order infinite-impulse response DFE (IIR-DFE). An IIR-DFE circuit is also proposed that obviates the need for an explicit full-rate multiplexor. Fabricated in 65 nm CMOS, the receiver achieves 0.705 pJ/b efficiency with the IIR-DFE consuming 150 fJ/b. Using a photodiode with 12 GHz analog bandwidth and responsivity of 0.5 A/W, the receiver has a sensitivity of -5.8 dBm optically modulated amplitude.
10 November 2022 in IEEE Journal of Solid-State Circuits
A flip-chip co-packaged linear transimpedance amplifier (TIA) in 16-nm fin field effect transistor (FinFET) CMOS demonstrating 112-Gb/s four-level pulse-amplitude modulation (4-PAM) with −8.2-dBm sensitivity is presented in support for optical receivers required in the next-generation intra-data center links. A proposed three-stage TIA is comprised of a shunt-feedback stage followed by digitally programmable continuous-time linear equalizers (CTLEs) and a variable gain amplifier (VGA). Broadband low-noise design is achieved by having the first stage with much lower bandwidth (BW) followed by the proposed BW recovering CTLEs. A low-power design is supported by the inverter-based single-ended architecture with a single-ended-to-pseudo-differential conversion in the last stage. TIA’s BW extension is further supported by optimizing the photodiode-to-receiver (PD-to-RX) interconnect and utilizing several inductive peaking techniques. It achieves 63-dB $\Omega $ gain, 32-GHz BW, and an average input-referred current noise density of 16.9 pA/ $\sqrt {\text {Hz}}$ while operating at 0.9-V supply and consuming 47-mW power. Opto-electrical measurements are performed on a co-packaged prototype comprised of identical proposed TIAs in CMOS with combinations of various commercial PDs and PD-to-RX interconnect lengths confirming 112-Gb/s 4-PAM reception meeting pre-forward error correction (FEC) symbol error rate (SER) of $4.8 \times 10 ^{-4}$ without any post-equalization.