9 March 2016 in Biofouling
A test coupon coated with light calcareous tubeworm fouling was scanned, scaled and reproduced for wind-tunnel testing to determine the equivalent sand grain roughness ks. It was found that this surface had a ks = 0.325 mm, substantially less than the previously reported values for light calcareous fouling. This result was used to predict the drag on a fouled full scale ship. To achieve this, a modified method for predicting the total drag of a spatially developing turbulent boundary layer (TBL), such as that on the hull of a ship, is presented. The method numerically integrates the skin friction over the length of the boundary layer, assuming an analytical form for the mean velocity profile of the TBL. The velocity profile contains the roughness (fouling) information, such that the prediction requires only an input of ks, the free-stream velocity (ship speed), the kinematic viscosity and the length of the boundary layer (the hull length). Using the equivalent sandgrain roughness height determined from experiments, a FFG-7 Oliver Perry class frigate is predicted to experience a 23% increase in total resistance at cruise, if its hull is coated in light calcareous tubeworm fouling. A similarly fouled very large crude carrier would experience a 34% increase in total resistance at cruise.
1 August 2016 in Journal of Fluid Mechanics
The scale interactions occurring within a turbulent boundary layer are investigated in the presence of free-stream turbulence. The free-stream turbulence is generated by an active grid. The free stream is monitored by a single-component hot-wire probe, while a second probe is roved across the height of the boundary layer at the same streamwise location. Large-scale structures occurring in the free stream are shown to penetrate the boundary layer and increase the streamwise velocity fluctuations throughout. It is speculated that, depending on the extent of the penetration, i.e. based on the level of free-stream turbulence, the near-wall turbulence production peaks at different wall-normal locations than the expected location of $y^{+}\approx 15$ for a canonical turbulent boundary layer. It is shown that the large scales dominating the log region have a modulating effect on the small scales in the near-wall region; this effect becomes more significant with increasing turbulence in the free stream, i.e. similarly increasing $Re_{\unicode[STIX]{x1D706}_{0}}$ . This modulating interaction and its Reynolds-number trend have similarities with canonical turbulent boundary layers at high Reynolds numbers where the interaction between the large scales and the envelope of the small scales exhibits a pure amplitude modulation (Hutchins & Marusic,Phil. Trans. R. Soc. Lond.A, vol. 365 (1852), 2007, pp. 647–664; Mathiset al., J. Fluid Mech., vol. 628, 2009, pp. 311–337). This similarity has encouraging implications towards generalising scale interactions in turbulent boundary layers.
17 January 2019 in Fluid Dynamics Research
Many recent investigations on the scale interactions in wall-bounded turbulent flows focus on describing so-called amplitude modulation, the phenomenon that deals with the influence of large scales in the outer region on the amplitude of the small-scale fluctuations in the near-wall region. The present study revisits this phenomenon regarding two aspects, namely the method for decomposing the scales and the quantification of the modulation. First, the paper presents a summary of the literature that has dealt with either or both aspects. Second, for decomposing the scales, different spectral filters (temporal, spatial or both) and empirical mode decomposition (EMD) are evaluated and compared. The common data set is a well-resolved large-eddy simulation that offers a wide range of Reynolds numbers spanning Re
θ
= 880–8200. The quantification of the amplitude modulation is discussed for the resulting scale components. Particular focus is given to evaluate the efficacy of the various filters to separate scales for the range of Reynolds numbers of interest. Different to previous studies, the different methods have been evaluated using the same data set, thereby allowing a fair comparison between the various approaches. It is observed that using a spectral filter in the spanwise direction is an effective approach to separate the small and large scales in the flow, even at comparably low Reynolds numbers, whereas filtering in time should be approached with caution in the low-to-moderate Re range. Additionally, using filters in both spanwise and time directions, which would separate both wide and long-living structures from the small and fast scales, gives a cleaner image for the small-scales although the contribution to the scales interaction from that filter implementation has been found negligible. Applying EMD to decompose the scales gives similar results to Fourier filters for the energy content of the scales and thereby for the quantification of the amplitude modulation using the decomposed scales. No direct advantage of EMD over classical Fourier filters could be seen. Potential issues regarding different decomposition methods and different definitions of the amplitude modulation are also discussed.
2 August 2017 in Experiments in Fluids
This experimental investigation deals with the influence of free-stream turbulence (FST) produced by an active grid on the skin friction of a zero-pressure-gradient turbulent boundary layer. Wall shear stress is obtained by oil-film interferometry. In addition, hot-wire anemometry was performed to obtain wall-normal profiles of streamwise velocity. This enables the skin friction to be deduced from the mean profile. Both methods show remarkable agreement for every test case. Although skin friction is shown to increase with FST, the trend with Reynolds number is found to be similar to cases without FST. Furthermore, once the change in the friction velocity is accounted for, the self-similarity of the logarithmic region and below (i.e. law of the wall) appears to hold for all FST cases investigated.
29 March 2021 in Journal of Fluid Mechanics
The instantaneous structure of a turbulent boundary layer that has developed beneath freestream turbulence (FST) was investigated with planar particle image velocimetry. Measurements were performed in the streamwise–wall-normal plane at a position downstream of the boundary layer origin. FST was generated with an active grid placed upstream of a boundary layer plate. Three cases were investigated with FST intensity increasing from approximately zero to 12.8 %. It is shown that internal interfaces, separating areas of approximately uniform momentum, are present for all cases and show a dependence on the FST. In particular, the number and length of the uniform-momentum zones (UMZs) decrease with increasing FST. The modal velocities associated with the UMZs are distributed in approximately the same way regardless of the condition of the outer flow, suggesting a degree of resilience of the instantaneous structure to the freestream. Tracking the top edge of the upper-most UMZ revealed that this contour approaches the wall for increasing FST. Finally, it is demonstrated that the observed first-order phenomena in a turbulent boundary layer subjected to FST can be modelled by superimposing an isotropic turbulence field on a turbulent boundary layer field, which supports the hypothesis that the underlying structure of the boundary layer appears to remain largely intact if the naturally occurring fluctuations in the turbulent boundary layer exceed the energy of the FST.
20 July 2018 in Journal of Fluid Mechanics
The influence of the large scale organisation of free-stream turbulence on a turbulent boundary layer is investigated experimentally in a wind tunnel through hot-wire measurements. An active grid is used to generate high-intensity free-stream turbulence with turbulence intensities and local turbulent Reynolds numbers in the ranges $7.2\,\%\leqslant u_{\infty }^{\prime }/U_{\infty }\leqslant 13.0\,\%$ and $302\leqslant Re_{\unicode[STIX]{x1D706},\infty }\leqslant 760$ , respectively. In particular, several cases are produced with fixed $u_{\infty }^{\prime }/U_{\infty }$ and $Re_{\unicode[STIX]{x1D706},\infty }$ , but up to a 65 % change in the free-stream integral scale $L_{u,\infty }/\unicode[STIX]{x1D6FF}$ . It is shown that, while qualitatively the spectra at various wall-normal positions in the boundary layer look similar, there are quantifiable differences at the large wavelengths all the way to the wall. Nonetheless, profiles of the longitudinal statistics up to fourth order are well collapsed between cases at the same $u_{\infty }^{\prime }/U_{\infty }$ . It is argued that a larger separation of the integral scale would not yield a different result, nor would it be physically realisable. Comparing cases across the wide range of turbulence intensities and free-stream Reynolds numbers tested, it is demonstrated that the near-wall spectral peak is independent of the free-stream turbulence, and seemingly universal. The outer peak was also found to be described by a set of global scaling laws, and hence both the near-wall and outer spectral peaks can be predicted a priori with only knowledge of the free-stream spectrum, the boundary layer thickness ( $\unicode[STIX]{x1D6FF}$ ) and the friction velocity ( $U_{\unicode[STIX]{x1D70F}}$ ). Finally, a conceptual model is suggested that attributes the increase in $U_{\unicode[STIX]{x1D70F}}$ as $u_{\infty }^{\prime }/U_{\infty }$ increases to the build-up of energy at large wavelengths near the wall because that energy cannot be transferred to the universal near-wall spectral peak.