In this paper, the 2f/1f tunable diode laser wavelength modulation spectroscopy is used for the simultaneous measurement of concentration and temperature of CO 2 in the exhaust plume of an aero engine. The suitability of the R48 spectral feature of CO 2 at 1997.2 nm is discussed for this project and for further application of CO 2 tomographic imaging on large-scale aero-engines. To ensure accurate recovery of gas parameters at the high exhaust temperatures, a full spectral characterization of the absorption feature is presented using a direct spectroscopy. The 2f/1f method is validated in the laboratory for controlled gas mixtures and temperatures to recover concentration and temperature. Good agreement with the actual temperature and concentration values is demonstrated. Finally, single path measurements are presented for an aero engine exhaust showing good correlation with the measured engine conditions.
We report on the development of three systems intended to provide fast, non-intrusive measurement of cross-sectional distributions of pollutant species within gas turbine exhaust flows, during ground-based testing. This research is motivated by the need for measurement systems to support the introduction of technologies for reducing the environmental impact of civil aviation. Tomographic techniques will allow estimation of the distributions of CO 2 , unburnt hydrocarbons (UHC), and soot, without obstruction of the exhaust, bypass or entrained flows, from measurements made in a plane immediately aft of the engine.
Here we present the latest developments in tomographic imaging of gas turbine exhaust species, particularly CO2. The optical source, detection methodology and mechanical optical distribution design are discussed in detail.
Measurement of gas concentration and temperature distribution at high repetition rates in a plasma chemical reactor is important for the optimization of the reactor performance, for example, by placing more catalysts in the reaction zones. Tunable diode laser absorption spectroscopy combined with focal planar arrays is an effective method used for fast mapping of concentration and temperature in gaseous flows. A custom two dimensional (2D) high temperature gas flow cell has been constructed for the validation of the concept. An interband cascade laser and a focal planar array camera (Infratec ImageIR 5355) is employed for detection; 2D beam expanding optics to image the flow cell. The technique will be further developed for calibration and measurement of temperature and concentration, improvement of the speed etc., towards the realization of fast concentration and temperature measurements in a plasma reactor, targeting key plasma catalytic reactions such as methane valorization involving conversion of greenhouse gases such as methane to useful industrial precursors.