1 July 2014 in IEEE Transactions on Plasma Science
While interrupting the large current in vacuum circuit breaker, the surface temperature of both electrodes will rise due to the arc current Joule heating process; the surface profile gets rough due to the vacuum arc burning on electrodes nonuniformly; and protrusions are simultaneously generated, which may potentially lead to late discharge. In this paper, the random discharge after current zero is reported, and the particle phenomenon is observed as considered to be responsible for the late discharge phenomenon previously. The authors develop a synthetic experiment system, which consists of current source, voltage source, control units, and the observation system. The high-speed video camera is used to record the particle motion in the interelectrode space. Using this system, the motion of small particles is tracked. From the particle information in each frame, the size and speed of the particle are calculated to be within 160 μm and 100 m/s, respectively; the charge quantity of small particles is derived as less than 10-11 C. Furthermore, the surface field enhancement factor is deduced from the particle detachment model, which lays in hundred orders. Since observed particles cannot directly lead to the observed current, possible reasons for the late discharge would be Townsend type metal vapor discharge, and the vapor comes from high-temperature electrode surface and protrusions.
14 May 2020 in IEEE Transactions on Plasma Science
Interelectrode phenomena related to intense-mode vacuum arc interruption were systematically compared between CuCr and AgWC electrodes by using various optical techniques mainly including two-color pyrometry for anode temperature determination after current zero, optical emission spectroscopy for the plasma composition assessment, and a Shack-Hartmann method for simultaneous 2-D electron and metal vapor density imaging. At the current peak, the widths of the radial electron density distributions for CuCr were narrower than those for AgWC. The electron density for CuCr was 3-5 times higher than that for AgWC. At current zero, the metal vapor density for CuCr was slightly lower than that for AgWC, which was specifically demonstrated for CuCr by a locally reduced metal vapor density below the minimum detectable limit of 10²⁰ m⁻³. During and after the arcing time, mixing ratios of the copper vapor existing in the CuCr gap was about two times higher than expected from the CuCr electrode composition. After current zero, the decaying time constants of the metal vapor densities on the anode surfaces were Cr < Cu < Ag. This order was consistent with the decaying time constants of the anode evaporation rates estimated from the anode temperature measurement. The consistency suggests that the supplying process of the metal vapor after the intense vacuum arc interruption was the evaporation of the anode surfaces.