In this research an effort is made to investigate the machining of Incoloy 800H Super alloy which is hard to machine material due to its rapid hardening property. Laser textured cryogenically treated cutting inserts and vegetable oil enriched with ZnO nano particles through Minimum Quantity Lubrication (MQL) was used. Turning experiments were performed based on L27 Orthogonal Array (OA). Cutting speed, feed rate, and depth of cut were the input parameters. Surface roughness, cutting force, micro hardness, tool-tip temperature, power and material removal rate were the responses measured. Taguchi based Grey Relational Analysis and Analysis of Variance were used to optimize and find the most influencing parameter. The results revealed that the optimal machining conditions were cutting speed at 35 m/min, feed rate at 0.06 mm/rev and depth of cut at 0.5 mm for the multiple-characteristic performances and it was improved by 4.87%. Microhardness, Tool-tip temperature and Power were reduced during machining to 1.31%, 4.53% and 2.10% respectively. Moreover, ZnO nanoparticles enriched base fluid gives better performances in terms of surface roughness, tool wear and cutting force. Furthermore, the White Light Interferometer (WLI) and Scanning Electron Microscopy (SEM) were used to study the machined surface topography and tool wear analysis.
Incoloy 800H (Fe–Ni–Cr) is an iron-based superalloy that is difficult to machine because of its rapid work-hardening behaviour. Although Taguchi-based grey relational analysis has previously been applied to machining optimisation problems, studies employing an integrated grey-fuzzy framework for the dry turning of Incoloy 800H remain limited. Therefore, the present investigation aims to develop and validate a grey-fuzzy optimisation approach for determining the optimal dry turning parameters of Incoloy 800H by simultaneously minimising machining forces, surface roughness, and specific cutting pressure. Cutting speed (35, 45, and 55 m/min), feed rate (0.02, 0.04, and 0.06 mm/rev), and depth of cut (0.5, 0.75, and 1 mm) were selected as input factors, whereas feed force, thrust force, cutting force, surface roughness, and specific cutting pressure were considered output responses. Experiments were conducted using a Taguchi L27 orthogonal array (OA). The proposed methodology integrates grey relational analysis (GRA) with fuzzy logic (FL) to obtain a grey-fuzzy reasoning grade (GFRG) for multi-response optimisation. Analysis of variance (ANOVA) was employed to identify the most influential machining parameter. The results demonstrated that the grey-fuzzy approach provided a more discriminative optimisation index than conventional grey relational analysis by reducing uncertainty in multi-response decision-making. The confirmation experiments revealed an increase in GFRG from 0.550 to 0.900, corresponding to a relative improvement of 63.64% at the optimal parameter setting. The proposed methodology demonstrates that integrating grey relational analysis with fuzzy inference provides a reliable and statistically supported approach for multi-response optimisation of dry turning parameters for Incoloy 800H.