27 August 2019 in Journal of Chemistry
In this work, zeolite (Z) and Z-Fe3O4nanocomposite (Z-Fe3O4NC) have been synthesized. The Fe3O4nanoparticles were synthesized using the extract from maize leaves and ferric and ferrous chloride salts and encapsulated into the zeolite framework. The nanocomposite (Z-Fe3O4NC) was characterized using X-ray diffractometer (XRD), Fourier-transform infrared (FT-IR) spectroscopy, energy-dispersive X-ray (EDX) spectroscopy, and scanning electron microscopy (SEM). The potential of Z-Fe3O4NC as an adsorbent for removing methylene blue molecules (MB) from solution was examined using UV-Vis and kinetic and equilibrium isotherm models. The adsorption data fitted best with the pseudo-second-order model and Weber and Morris model, indicating that the adsorption process was chemisorption, while the Weber and Morris described the rate-controlling steps. The intraparticle diffusion model suggests that the adsorption processes were pore and surface diffusion controlled. The Langmuir isotherm model best describes the adsorption process indicating homogeneous monolayer coverage of MB molecules onto the surface of the Z-Fe3O4NC. The maximum Langmuir adsorption capacity was 2.57 mg/g at 25°C. The maximum adsorption efficiency was 97.5%. After regeneration, the maximum adsorption efficiency achieved at a pH of 7 was 82.6%.
12 May 2021 in RSC Advances
Synthesis scheme of the Ag 3 PO 4 –TiO 2 nanocomposite.
1 January 2018 in Cogent Engineering
RARichard Yeboah Abrokwah
+1
Zeolites have been hydrothermally synthesized using alumina and silica based deposits (kaolin, bauxite, silica and feldspar) sampled from three regions in Ghana and the chemical compositions of the zeolites varied by batch formulations. The as-synthesized zeolites were characterized using X-ray Diffraction, Fourier Transform Infra-Red and Porosimetry techniques. The morphology and elemental compositions were examined using Scanning Electron Microscopy and energy dispersive X-ray spectroscopy (EDX). The results indicate that zeolite A was formed with a cubic structure and structural variations depending on the batch formulations. By increasing the silica content (Si/Al ratio) through batch formulations, the crystallite sizes of zeolites increased forming Zeolite A with LTA structure and Zeolite A (K-exchanged dehydrated). Samples with higher alumina content produced Zeolite A (Hydrated), Zeolite-Na and Zeolite A (Na, Dehydrated) with lower crystallite sizes. The zeolite synthesized was then used in the synthesis of zinc exchanged Zeolite A (Zn-zeolite A). EDX analysis confirmed a complete exchange of Na in the Zeolite framework with Zn and the feasibility as an adsorbent for methylene blue tested. The synthesized Zn-exchanged Zeolite A showed strong adsorption for methylene blue dye. The adsorption kinetics of the MB onto Zn-exchanged Zeolite A was observed to follow pseudo-second-order model. Freundlich model better described the interaction among adsorbate molecules onto the Zn-exchanged Zeolite A adsorbent, suggesting a multilayer distribution of adsorbate molecules with some level of interaction between adsorbed molecules. The regeneration capacity of the adsorbent was low and calculated to be about 48% at pH of 12.