This article reports the Phase A study results of the interferometric extension of the high-resolution wide-swath (HRWS) mission with three MirrorSAR satellites. According to the MirrorSAR concept, small, low-cost, transponder-like receive-only satellites without radar signal demodulation, digitization, memory storage, downlink, and synchronization are added to the planned German X-band HRWS mission. The MirrorSAR satellites fly a triple helix orbit in close formation around the HRWS orbit and span multiple single-pass interferometric baselines. A comprehensive system engineering and performance analysis is provided that includes orbit formation, MirrorLink, Doppler steering, antenna pattern and swath design, multi-static echo window timing, SAR performance, height performance, and coverage analysis. The overall interferometric system design analysis of Phase A is presented. The predicted performance of the global digital elevation model (DEM) is improved by one order of magnitude compared to presently available global DEM products such as the TanDEM-X DEM.
21 December 2017 in IEEE Transactions on Geoscience and Remote Sensing
This paper addresses the performance in the retrieval of 3-D mean deformation maps by exploiting simultaneous or quasi-simultaneous squinted synthetic aperture radar (SAR) interferometric acquisitions in a repeat-pass scenario. In multisatellite or multibeam low earth observation missions, the availability of two (or more) lines of sight (LOSs) allows the simultaneous acquisition of SAR images with different squint angles, hence improving the sensitivity to the north-south component of the deformation. Due to the simultaneity of the acquisitions, the troposphere will be highly correlated and, therefore, will tend to cancel out when performing the differential measurement between the interferograms obtained with the different LOSs, hence resulting in a practically troposphere-free estimation of the along-track deformation measurement. In practice, however, the atmospheric noise in the differential measurement will increase for increasing angular separations. This paper expounds the mathematical framework to derive the performance by properly considering the correlation of the atmospheric delays between the simultaneous acquisitions. To that aim, the hybrid Cramér-Rao bound is exploited making use of the autocorrelation function of the troposphere. Some performance examples are presented in the frame of future spaceborne SAR missions at C and L band.
28 January 2022 in IEEE Transactions on Geoscience and Remote Sensing
Observations of wind- and ocean surface velocity vectors by Along-Track Interferometry (ATI) with the Synthetic Aperture Radar (SAR) are not only important for direct applications, but also to increase understandings of ocean upper-layer mixing, air-ocean interactions, and mapping submesoscale (1-10 km) structures. Experimental Bidirectional(BiDi) ATI acquisition mode of TanDEM-X observes with two squinted beams separated by an angle of approximately 13.2 degree in azimuth on the ground. The baseline is very short, and the ATI phase of the ocean surface in line-of-sight direction of the beams can be interpreted as a total Doppler velocity. The 2-dimensional Doppler velocity field will thus include wind wave detected motions. In this paper, Doppler velocity fields acquired from this experimental acquisition mode are presented. The sequential retrieval of wind- and total surface current vectors is demonstrated on the bidirectional TanDEM-X data. The retrieval algorithm builds on existing Geophysical Model Functions (GMF) of NRCS and Doppler velocity. XMOD2 and a GMF based on the Elfouhaily Ocean Wave Spectrum coupled with a Kirchhoff Approximation (EOWS&KA) are used respectively. The retrieved wind fields are generally consistent with ECMWF ERA-5. Where the ATI phase errors are small, the retrieved TSCV field looks promising. Acquisitions were located at sea over the tip of the Novaya Zemlya in Russia and over an area near Tromsø, Norway.
1 January 2026 in IEEE Transactions on Radar Systems