Sentinel-1B is the second of two C-Band Synthetic Aperture Radar (SAR) satellites of the Sentinel-1 mission, launched in April 2016—two years after the launch of the first satellite, Sentinel-1A. In addition to the commissioning of Sentinel-1B executed by the European Space Agency (ESA), an independent system calibration was performed by the German Aerospace Center (DLR) on behalf of ESA. Based on an efficient calibration strategy and the different calibration procedures already developed and applied for Sentinel-1A, extensive measurement campaigns were executed by initializing and aligning DLR’s reference targets deployed on the ground. This paper describes the different activities performed by DLR during the Sentinel-1B commissioning phase and presents the results derived from the analysis and the evaluation of a multitude of data takes and measurements.
12 May 2017 in IEEE Geoscience and Remote Sensing Letters
The coregistration of synthetic aperture radar images is of fundamental importance for the generation of interferograms. The high azimuth coregistration requirements imposed by the TOPS acquisition mode imply that an advanced approach for the coregistration of stacked time series images is needed due to temporal decorrelation effects. In some scenarios, the conventional approach of estimating the shifts pairwise with respect to the same master might result insufficient. Therefore, a joint estimation is proposed here, which exploits jointly all interferograms in order to retrieve more accurate results. Simulated data and Sentinel-1A images acquired in IW mode are used to validate this procedure, demonstrating the better performance of the joint approach when compared to the standard single-master approach.
21 December 2017 in IEEE Transactions on Geoscience and Remote Sensing
This paper addresses the performance in the retrieval of 3-D mean deformation maps by exploiting simultaneous or quasi-simultaneous squinted synthetic aperture radar (SAR) interferometric acquisitions in a repeat-pass scenario. In multisatellite or multibeam low earth observation missions, the availability of two (or more) lines of sight (LOSs) allows the simultaneous acquisition of SAR images with different squint angles, hence improving the sensitivity to the north-south component of the deformation. Due to the simultaneity of the acquisitions, the troposphere will be highly correlated and, therefore, will tend to cancel out when performing the differential measurement between the interferograms obtained with the different LOSs, hence resulting in a practically troposphere-free estimation of the along-track deformation measurement. In practice, however, the atmospheric noise in the differential measurement will increase for increasing angular separations. This paper expounds the mathematical framework to derive the performance by properly considering the correlation of the atmospheric delays between the simultaneous acquisitions. To that aim, the hybrid Cramér-Rao bound is exploited making use of the autocorrelation function of the troposphere. Some performance examples are presented in the frame of future spaceborne SAR missions at C and L band.
Capella's first commercial Synthetic Aperture Radar (SAR) satellite was launched in August 2020. After more than one year of successful operations, Capella plans a continuous growth of both number of satellites and satellite capabilities. New tasking patterns allow the collection of pairs and time series of very high resolution (VHR) SAR images. A novel repeat tasking request pattern will enable SAR applications such as change detection and the exploitation of interferometric SAR (InSAR) techniques. The combination of on-board GPUs and dedicated on-board processing algorithms will be used for rapid target detection and minimized satellite downlink. On-board processing, applicable in many quasi real-time operational scenarios, can also be used for tipping and cueing other satellites to immediately capture a high resolution imagery. Finally, Capella Space Open Data program started in 2021 with new images added each quarter.
21 March 2022 in IEEE Geoscience and Remote Sensing Letters
This letter proposes the exploitation of the overlapping areas between bursts of Sentinel-1 interferometric wide (IW) swath data for the estimation of ground azimuth deformation velocities from time series, which provides high sensitivity to the North–South direction. The availability of two separated Doppler spectral looks over these areas allows one to obtain high accurate estimates, overcoming the limited performance of classical correlation techniques with coarse resolution modes. Since the estimation is restricted to the (sparsely distributed) burst overlaps, its applicability is limited to geophysical phenomena characterized by a slow spatial variability, e.g., seismic scenarios. We demonstrate the suitability of this approach to time series over a region in Pakistan affected by post-seismic deformation. The estimated mean azimuth velocity performance from real data indicates an accuracy better than 7 mm/year over high long-term coherent areas for a three-year data stack.
This paper presents results of the Sentinel-1 sensor in the interferometric wide-swath (IW) mode encompassing the first two years of operation of the mission. The paper focuses on persistent scatterer interferometric results and their validation. Further applications and investigations are also addressed, e.g., earthquakes, volcanoes and tomography.