An increasing number of textiles is being functionalized using magnetron sputtering. A wide spectrum of colors can be produced by coating thin films on textiles via magnetron sputtering, which reduces pollution issues by bypassing the high requirements of water, chemical dyes, and auxiliary setups of traditional textile dyeing. By covering single-layer, double-layer, or multilayer films with metal, semiconductor, or ceramic targets possessing a particular structure, composition, thickness, and morphology using the magnetron sputtering method, metallic colors or interference structural colors have been successfully produced on textile surfaces. Intelligent, decorative, and practical products use coated colors and other features. Herein, we review the research advancements in textile coloring and applications of colored textiles coated by sputtering, including the sputter deposition technique, color-generating mechanism, and principles of the color regulation of sputtered thin films. The difficulties and future directions for research on colored sputtered thin films in textiles is also summarized.
Poly(vinylamine) (PVAm) is an important polymer with the highest content of primary amine groups of any polymer. PVAm has a great potential in selective separation and smart materials. It is difficult to fabricate pure PVAm nanofibers by electrospinning and rotary jet spinning (RJS) without additional polymers. In this work, rotary jet wet spinning (RJWS) was applied to fabricate molecular imprinting nanofibers (MINFs) with polyelectrolyte for the first time. Initially, optimal parameters of spinning are investigated, including coagulation bath, solution viscosity, and rotation speed. The PVAm aqueous solution is sensitive to alcohol. To demonstrate RJWS application, PVAm-based MINFs for bisphenol A (one endocrine disruptor) recognition are prepared by adding dummy template, cross-linking, and template elution. The association constant (8.6 mg/L), equilibrium time (30 min), and binding sites utilization rate (80%) of MINFs are evaluated. Its adsorption amount and selectivity are little lower than those of MIPs prepared by bulk polymerization; however, its adsorption speed is faster than that of MIPs.