1 November 2000 in Europhysics Letters
A strong dependence of tunnel magnetoresistance (TMR) on the crystal ori- entation of ferromagnetic electrodes was confirmed experimentally. We studied the TMR of Fe/Al2O3/Fe 50Co50 tunnel junctions with single-crystal Fe electrodes of different crystal orien- tations and found that the TMR ratio increased from 13% to 42% at 2K (8% to 26% at room temperature) when the crystal orientation was changed from (100) to (211). Such a TMR anisotropy could be explained in terms of the anisotropic spin polarization of Fe bulk and/or interface electronic states. The importance of the "momentum-filtering" effect of the tunnel barrier was also discussed.
23 January 2006 in Applied Physics Letters
Using double-junction stack technology we have demonstrated a programmable Josephson voltage standard chip that operates up to output voltage cooled with a two-stage Gifford–McMahon cryocooler. The circuit uses double-junction stacks, where two junctions are fabricated in each stack, in order to integrate 327 680 junctions into a chip. A 1-to-32 microwave distribution circuit is also integrated on the chip. The chip is divided into 22 cells, which perform as an digital-to-analog converter. The 21 working cells include 307 200 junctions biased with microwaves at that generated flat voltage steps with current margins greater than , which indicates good uniformity of the stacked junctions.
1 May 2018 in Physica C: Superconductivity and its Applications
23 July 2008 in Superconductor Science and Technology
21 November 2001 in Superconductor Science and Technology
Five-bit all-NbN digital-to-analog converters (DACs) for a programmable voltage standard have been fabricated using NbN/TiNx/NbN Josephson junctions and their operation has been demonstrated. The DAC consists of six arrays of 128, 128, 256, 512, 1024 and 2048 junctions per array. We have measured the current–voltage characteristics for the junction arrays driven with a 16 GHz microwave signal at 4.2 and 10 K, resulting in constant-voltage steps with heights larger than 2 mA. The maximum output voltage for the DAC was 136 mV, indicating that all 4096 junctions in the DAC yielded a voltage corresponding to the microwave frequency through the ac Josephson effect.
1 January 2013 in IEEE Transactions on Applied Superconductivity
Resonant frequencies and SQUID inductances L S in a microwave SQUID multiplexer are studied for the purpose of reliable design applicable for a future large-format array of transition edge sensors (TESs). The key element of the multiplexer chip is a quarter-wave-length resonator terminated by a dissipationless rf SQUID connected to TES. For the resonator, we found that a small correction to the effective length of the resonators made the designed resonant frequencies fit the experimental one over the whole readout band of 4-8 GHz covered by our cryogenic amplifier. We also found that microstrip-type SQUIDs with vertical loops are suitable for accurate design of small inductance L S <; 10<; pH to operate the rf SQUID in dissipationless regime. Based on these well-designed resonators and SQUIDs, we have successfully demonstrated the multiplexing of three pulsed signals with 1-ms width and spacing given at the input ports of three SQUIDs. The equivalent noise current refer to the SQUID input is not dominated by SQUIDs and estimated to be 200-270 pA/ √Hz, whose improvement approach is quantitatively discussed.