Fuminori Hirayama

Fuminori Hirayama

Auto-generated profile, based on publicly available information

Fuminori Hirayama

National Institute of Advanced Industrial Science and Technology

Research Focus & Metrics

Academic Career Length

36Years (1991-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2013 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
FHFuminori Hirayama
Fuminori Hirayama
SKSatoshi Kohjiro
Satoshi Kohjiro
DFDaiji Fukuda
Daiji Fukuda
HYHirotake Yamamori
Hirotake Yamamori
SNShuichi Nagasawa
Shuichi Nagasawa
MHMutsuo Hidaka
Mutsuo Hidaka
Resonant frequencies and SQUID inductances L S in a microwave SQUID multiplexer are studied for the purpose of reliable design applicable for a future large-format array of transition edge sensors (TESs). The key element of the multiplexer chip is a quarter-wave-length resonator terminated by a dissipationless rf SQUID connected to TES. For the resonator, we found that a small correction to the effective length of the resonators made the designed resonant frequencies fit the experimental one over the whole readout band of 4-8 GHz covered by our cryogenic amplifier. We also found that microstrip-type SQUIDs with vertical loops are suitable for accurate design of small inductance L S <; 10<; pH to operate the rf SQUID in dissipationless regime. Based on these well-designed resonators and SQUIDs, we have successfully demonstrated the multiplexing of three pulsed signals with 1-ms width and spacing given at the input ports of three SQUIDs. The equivalent noise current refer to the SQUID input is not dominated by SQUIDs and estimated to be 200-270 pA/ √Hz, whose improvement approach is quantitatively discussed.

21 September 2020 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
YNY. Nakashima
Y. Nakashima
FHF. Hirayama
F. Hirayama
SKS. Kohjiro
S. Kohjiro
HYH. Yamamori
H. Yamamori
SNS. Nagasawa
S. Nagasawa
JHJ. W. A. Den Herder
J. W. A. Den Herder
We report very-low-noise, fast-response, middle-scale multiplexing in a microwave superconducting quantum interference device multiplexer (MW-Mux) as a transition-edge sensor (TES) readout. Our MW-Mux is able to read 40 channels with 500 kHz sampling and has a low readout noise of 0.9   μ Φ 0 / Hz (where Φ 0 is the magnetic flux quantum), equivalent to 9   pA / Hz . By contrast, a multiplexer of less than 10 pixels with 500 kHz sampling and ∼ 2   μ Φ 0 / Hz readout noise has so far been reported in the literature. Owing to the 500 kHz sampling, our MW-Mux exhibits a fast response to detect a TES pulse with a rise time around 12   μ s . We demonstrated simultaneous readout of 38 pixels from an array of x-ray TES microcalorimeters. The measured full-width values at half-maximum spectral resolution ranged from 2.79 to 4.56 eV, with a median value of 3.30 eV at 5.9 keV, including a ∼ 10 % contribution of readout noise, i.e., 0.9–1.7 eV.

1 October 2004 in Physica C: Superconductivity and its Applications
Verified
Journal Article
Closed access
MMMasaaki Maezawa
Masaaki Maezawa
FHFuminori Hirayama
Fuminori Hirayama
MSMotohiro Suzuki
Motohiro Suzuki

1 October 2005 in Physica C: Superconductivity and its Applications
Verified
Journal Article
Closed access
MMMasaaki Maezawa
Masaaki Maezawa
FHFuminori Hirayama
Fuminori Hirayama
MSMotohiro Suzuki
Motohiro Suzuki

1 June 1999 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
MSM. Suzuki
M. Suzuki
MMM. Maezawa
M. Maezawa
HTH. Takato
H. Takato
HNH. Nakagawa
H. Nakagawa
FHF. Hirayama
F. Hirayama
ASA. Shoji
A. Shoji

27 February 2023 in Physical Review Research
Verified
Journal Article
Open access
PDF file
NTNaoki Takeuchi
Naoki Takeuchi
TYTaiki Yamae
Taiki Yamae
WLWenhui Luo
Wenhui Luo
FHFuminori Hirayama
Fuminori Hirayama
TYTsuyoshi Yamamoto
Tsuyoshi Yamamoto
NYNobuyuki Yoshikawa
Nobuyuki Yoshikawa
Quantum processors have the potential to accelerate specific computing tasks but are difficult to scale up due to engineering limitations, such as the number of available cables and cooling power for dilution refrigerators for quantum bits (qubits). Hence, it is very important to develop scalable, energy-efficient interface circuits that can control many qubits via a few control lines inside a dilution refrigerator. One of the most important interface circuits is the flux controller (FC), which generates arbitrary dc flux bias to adjust the characteristics of component devices such as qubits. In this paper, we propose and demonstrate FCs using an energy-efficient superconductor logic family, adiabatic quantum-flux-parametron (AQFP) logic. We develop two types of FCs: the AQFP FC and the AQFP/single-flux-quantum (AQFP/SFQ) FC. Both FCs require only a few control lines and have extremely small power dissipation, thus exhibiting high scalability. Furthermore, the AQFP/SFQ FC can control flux bias using ballistic SFQ transmission, which is crucial for integration with qubits. As a proof of concept, we demonstrate AQFP and AQFP/SFQ FCs at 4.2 K, fabricated by the AIST high-speed standard process. Our results indicate that AQFP logic is highly suitable for use as qubit interface circuits for very large-scale quantum processors, especially from the viewpoint of the control line count, power dissipation, and amount of supply currents.