Mobile ad hoc networks (MANETs) are particularly suited for scenarios that demand rapid deployment of a communication system without any existing network resources. For instance, a MANET can facilitate the intercommunication process between members of a rescue party in a natural disaster, where the underlying routing protocol is crucial to maintaining the dissemination capability of data-critical packets. However, the backbone of every MANET, i.e., their routing protocol, is limited by the communication range of nodes, their high-speed mobility, and the capacity constraints of energy. This study proposed a fault-tolerant ad hoc on-demand routing protocol (FT-AORP) that relies on these characteristics of MANET nodes to determine reliable paths for data transmission. Subsequently, two of the discovered paths were used to transmit the duplicates of an original data packet to maximize fault tolerance. Further, using the OMNeT++ network simulator, the performance of the proposed system was evaluated through extensive simulation experiments against three simulation parameters: the number of network nodes, node speed, and data packet sending rate. The simulation results demonstrated that FT-AORP greatly improved the packet delivery ratio, reduced end-to-end delay, and maintained a higher residual energy level of the transmission path, compared to other baseline routing protocols.
Because there is always a demand for robust fault-tolerant automotive networks, recent works have focused particularly on replacing controller area networks (CANs) with more reliable protocols for time-critical bandwidth-demanding in-vehicle network (IVN) systems. However, as the automobile industry normally relies on proven technologies, an interim solution to fault-tolerance capability for CAN systems is still essential during the transition phase to other protocols. In this paper, we propose a novel fault-tolerant algorithm for the CAN protocol that we refer to as seamless CAN. Its operating concept is based on a high-availability seamless redundancy (HSR) implementation inside the vehicle network’s ring structure, and the fault tolerance is achieved by encapsulating the CAN frame inside the HSR frames and sending them in the ring topology. The simulation results showed that seamless CAN provided better performance regarding no frame loss in the case of link failures and up to ten times lower number of error occurrences.
Federated learning (FL) has emerged as a machine learning (ML) paradigm for distributed training without requiring trainers to share private data. Coevally, unmanned aerial vehicles (UAVs) become sufficiently powerful that they can contribute to training sophisticated ML models. Direct application of the conventional FL framework to a UAV swarm, however, could result in unnecessarily high communication and computation complexity. This paper aims to address this challenge by proposing a scalable and clustered FL framework for such large UAV swarms. Specifically, we develop a clustering scheme based on which the UAV-based wireless network is partitioned into different clusters coordinated by corresponding cluster-head UAVs forming a connected graph. While the cluster-head UAVs coordinate the ML model updates as in the conventional FL framework, we propose two intercluster model aggregation strategies to produce the final global model in each training round. Extensive numerical studies demonstrate the convergence and desirable trade-offs between training performance and communication efficiency of our proposed framework.
Unmanned aerial vehicle (UAV) communications can be leveraged for efficient data collection from widely distributed sensors in wireless sensor networks (WSNs). Integrating federated learning (FL) with UAV-enabled WSNs allows decentralized and privacy-preserving training of machine learning models, enabling different Internet-of-things applications. Achieving energy efficiency for such FL-based systems is important due to the limited battery capacities of both UAVs and sensors but it remains an open challenge to the best of our knowledge. To fill this research gap, we study the joint design of UAV trajectory, data transmission, and computational resource allocation and formulate it as an optimization problem aiming to minimize the total weighted energy consumed by sensors and UAVs. In order to solve the underlying difficult mixed-integer nonlinear optimization problem, we employ the alternating optimization approach, where we sequentially solve different sub-problems in each iteration until convergence. We show that the data transmission and computational resource allocation sub-problems can be transformed into linear integer and convex optimization problems, respectively. Meanwhile, the successive convex approximation method is employed to tackle the UAV trajectory control sub-problem. Via extensive simulations, we demonstrate the effectiveness of our approach, showcasing significant energy savings and improved performance compared to other benchmarks. We also analyze the impacts of key parameters and the trade-off between learning performance and energy consumption via numerical studies.
Due to the benefits of better bandwidth and reliability, the automotive industry is moving towards Ethernet-based in-vehicle network (IVN) systems as the number of onboard electronic control units has increased. Considering that before long the well-known controller area network (CAN) will still be considered a standard protocol, our earlier work introduced a high-availability seamless redundancy (HSR)-based Ethernet network architecture that provides IVNs with fault tolerance, called seamless CAN. However, HSR is known for its redundant traffic generated for fault tolerance, which is a disadvantage in bandwidth-limited IVN systems. Therefore, in this paper, we propose a traffic-effective architecture for seamless CAN-based networks. We compared the proficiency of different traffic-reduction approaches as they were applied to our proposed architecture. Extensive simulation results showed that our proposed solution could reduce up to 54% of the total network traffic compared to a conventional architecture while still being able to guarantee a high level of fault tolerance.
6 January 2026 in IEEE Wireless Communications Letters
To address scalability in semantic communication (SC), we propose a novel heterogeneous Mixture-of-Experts (HMoE)-based SC (HMoE-SC) design, particularly for text-based systems. Our model employs a heterogeneous expert pool and a channel-aware gating mechanism that dynamically selects experts to efficiently deal with the input token complexity and enhance the robustness against adverse channel conditions. This enables efficient scaling of model capacity, activating lightweight experts in favorable scenarios and larger ones when needed, thereby balancing task performance and computational efficiency. Experimental results on a semantic similarity classification task using the Quora Question Pairs dataset confirm our HMoE-SC design improves semantic accuracy while efficiently reducing inference cost compared to the state-of-the-art models.