11 March 2011 in The Journal of Physical Chemistry C
14 September 2011 in ACS Applied Materials & Interfaces
16 August 2011 in Journal of Materials Chemistry
By exploiting the presence of abundant carboxylic groups (–COOH) on graphene oxide (GO) and using EDC–NHS (1-ethyl-3-(3-dimethylaminopropyl) carbodiimide hydrochloride–N-hydroxysuccinimide) chemistry to covalently conjugate protein molecules, we demonstrate a novel electrochemical immunosensor for detection of antibody–antigen (Rabbit IgG–AntiRabbit IgG) interactions. The interactions were verified using Electrochemical Impedance Spectroscopy (EIS). Although GO is known to be a poor conductor, the charge transfer resistance (RP) of a GO modified glassy carbon electrode (GCE) was found to be as low as 1.26 Ω cm2. This value is similar to that obtained for reduced graphene oxide (RGO) or graphene and an order of magnitude less than bare GCE. The EIS monitored antibody–antigen interactions showed a linear increase in RP and the overall impedance of the system with increase of antibody concentration. Rabbit IgG antibodies were detected over a wide range of concentrations from 3.3 nM to 683 nM with the limit of detection (LOD) estimated to be 0.67 nM. The sensor showed high selectivity towards Rabbit IgG antibody as compared to non-complementary myoglobin. RGO modified GCE showed no sensing properties due to the removal of carboxylic groups which prevented subsequent chemical functionalization and immobilization of antigen molecules. The sensitivity and selectivity achievable by this simple label free technique hint at the possibility of GO becoming the electrode material of choice for future electrochemical sensing protocols.
29 September 2017 in ACS Applied Materials & Interfaces
22 December 2011 in Nanoscale
A platinum free counter electrode for dye sensitized solar cells was developed using graphene platelets (GP) supported nickel nanoparticles (NPs) as the active catalyst. Few layered GP were prepared by chemical oxidation of graphite powders followed by thermal exfoliation and reduction. The nanoparticles of nickel were deposited directly onto the platelets by pulsed laser ablation. The composite electrodes of GP and Ni nanoparticles (GP–Ni) thus obtained showed better performance compared to conventional Pt thin film electrodes (Std Pt) and unsupported Ni NPs. The efficiencies of the cells fabricated using GP–Ni, Std Pt and Ni NP CEs were 2.19%, 2% and 1.62%, respectively. The GP–Ni composite solar cell operated with an open circuit voltage of 0.7 V and a fill factor of 0.6. Electrochemical impedance spectroscopy using the I3 −/I−redox couple confirms lower values of charge transfer resistance for the composite electrodes, 4.67 Ω cm2 as opposed to 7.73 Ω cm2 of Std Pt. The better catalytic capability of these composite materials is also reflected in the stronger I3 −reduction peaks in cyclic voltammetry scans.
28 October 2014 in Nano Letters
We report the development of a semiconductor nanorod-carbon nanotube based platform for wire-free, light induced retina stimulation. A plasma polymerized acrylic acid midlayer was used to achieve covalent conjugation of semiconductor nanorods directly onto neuro-adhesive, three-dimensional carbon nanotube surfaces. Photocurrent, photovoltage, and fluorescence lifetime measurements validate efficient charge transfer between the nanorods and the carbon nanotube films. Successful stimulation of a light-insensitive chick retina suggests the potential use of this novel platform in future artificial retina applications.