Abdullah Demir

Abdullah Demir

Auto-generated profile, based on publicly available information

Abdullah Demir

UNAM - Institute of Materials Science and Nanotechnology, Bilkent University, Ankara, Trkiye

Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 June 2023 in Light: Science & Applications
Verified
Journal Article
Open access
PDF file
EŞEnes Şeker
Enes Şeker
BOBabak Olyaeefar
Babak Olyaeefar
KDKhalil Dadashi
Khalil Dadashi
SŞSerdar Şengül
Serdar Şengül
MTMohammad Hosain Teimourpour
Mohammad Hosain Teimourpour
ADAbdullah Demir
Abdullah Demir
Large-area lasers are practical for generating high output powers. However, this often comes at the expense of lower beam quality due to the introduction of higher-order modes. Here, we experimentally demonstrate a new type of electrically pumped, large-area edge-emitting lasers that exhibit a high power emission (∼0.4 W) and a high-quality beam (M2∼1.25). These favorable operational characteristics are enabled by establishing a quasi PT-symmetry between the second-order mode of a large area two-mode laser cavity and that of a single-mode auxiliary partner cavity, i.e., by implementing a partial isospectrality between the two coupled cavities. This in turn enlarges the effective volume of the higher-order modes. As a result, a selective pump applied via current injection into the main laser cavity can provide a stronger modal gain to the fundamental mode, and thus lead to lasing in the single mode regime after filtering out higher order transverse modes. The reported experimental results confirm this intuitive picture and are in good agreement with both theoretical and numerical analysis. Above all, the employed material platform and fabrication process are compatible with the industrial standards of semiconductor lasers. This work provides the first clear demonstration, beyond previous proof-of-concept studies, of the utility of PT-symmetry in building laser geometries with enhanced performance and, at the same time, useful output power levels and emission characteristics.

17 July 2015 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
ADAbdullah Demir
Abdullah Demir
MPMatthew Peters
Matthew Peters
RDRichard Duesterberg
Richard Duesterberg
VRVictor Rossin
Victor Rossin
EZErik Zucker
Erik Zucker
We present theoretical calculations investigating the output power limitations of GaAs-based semiconductor lasers and the experimental results showing significant improvement of output power. To understand the influence of power limitation mechanisms, semiconductor laser with standard and unfolded cavity designs is studied. Our analysis reveals that an unfolded cavity laser enables more homogeneous longitudinal gain and intracavity optical intensity with reduced levels as compared with the standard cavity. Hence, an unfolded laser has theoretically lower power penalties induced by linear and nonlinear effects. For a 5.7-mm long laser cavity with 100-μm wide aperture, the experimental results demonstrate 21-W output from standard cavity whereas the unfolded cavity design achieves 33-W at 920 nm, which is >55% enhancement of the output, confirming the prediction of the theoretical calculations. The method represents a major step toward understanding semiconductor laser power limitations and realizing higher power output by control of longitudinal gain and power profiles.

25 July 2005 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
YYY.O. Yilmaz
Y.O. Yilmaz
ADA. Demir
A. Demir
AKA. Kurt
A. Kurt
ASA. Serpenguzel
A. Serpenguzel
We report the observation of morphology-dependent resonances from silicon microspheres. The dropped channels are observed both in the transmission and elastic scattering spectra in the O-band. The filter drops approximately 23% of the power at the resonance wavelength. The highest observed quality factor for the morphology-dependent resonances was on the order of 10/sup 5/. These resonances have a linewidth of 0.007 nm and a mode spacing of 0.19 nm.

16 April 2021 in IEEE Photonics Journal
Verified
Journal Article
Open access
YZYuliang Zhao
Yuliang Zhao
Zhenfu WangZhenfu Wang
Zhenfu Wang
ADAbdullah Demir
Abdullah Demir
GYGuowen Yang
Guowen Yang
SMShufang Ma
Shufang Ma
BQBocang Qiu
Bocang Qiu
We report on the development of a 940-nm diode laser bar based on epitaxially stacked active regions by employing a tunnel junction structure. The tunnel junction and the device parameters were systematically optimized to achieve high output and power conversion efficiency. A record quasi-continuous wave (QCW) peak power of 1.91 kW at 25 °C was demonstrated from a 1-cm wide bar with a 2-mm cavity length at 1 kA drive current (200 μs pulse width and 10 Hz repetition rate). Below the onset of the thermal rollover, the slope efficiency was as high as 2.23 W/A. The maximum power conversion efficiency of 61.1% at 25 °C was measured at 300 A. Reducing the heatsink temperature to 15 °C led to a marginal increase in the peak power to 1.95 kW.

19 September 2022 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
YLYuxian Liu
Yuxian Liu
GYGuowen Yang
Guowen Yang
YZYongming Zhao
Yongming Zhao
STSong Tang
Song Tang
YLYu Lan
Yu Lan
ADAbdullah Demir
Abdullah Demir
Improving the power and efficiency of 9xx-nm broad-area laser diodes has a great help in reducing the cost of laser systems and expanding applications. This letter presents an optimized epitaxial structure with high power and conversion efficiency. Laser diodes with 230 $\mu \text{m}$ emitter width and 5 mm cavity length deliver continuous-wave output power up to 48.5 W at 48 A, 30 °C, the highest power reported for 9xx-nm single emitter lasers so far. The slope efficiency is as high as 1.23 W/A due to a low internal optical loss of 0.31 cm−1 and a high internal efficiency of 96%. The maximum power conversion efficiency reaches 72.6% at 15.3 W and 67.3% at the operating power of 30 W under a heatsink temperature of 25 °C. Life test results show no failure in 1000 hours for 55 laser diodes.

21 September 2021 in Semiconductor Science and Technology
Verified
Journal Article
Closed access
YLYu Lan
Yu Lan
GYGuowen Yang
Guowen Yang
YLYuxian Liu
Yuxian Liu
YZYuliang Zhao
Yuliang Zhao
ZWZhenfu Wang
Zhenfu Wang
ADAbdullah Demir
Abdullah Demir
Semiconductor lasers with high power conversion efficiency (PCE) and output power are heavily investigated driven by more energy-efficient commercial applications. In this paper, an asymmetric broad area laser (A-BAL) design is studied and compared with a conventional symmetric broad area laser (S-BAL) design for 808 nm single emitter laser diodes. We present a comparative theoretical and experimental investigation by studying the thermal effects on the laser parameters. The output characteristics and efficiency loss paths for the designs were analyzed. The leakage of carriers was identified as the primary source of the PCE reduction with temperature. Suppressing this leakage by optimization of the A-BAL design, a record continuous-wave PCE of 68% at 25 °C and 60.4% at 75 °C were achieved for a single emitter laser with 10 W output power. These devices deliver high efficiency at high temperatures with reliable operation achieving 2000 h of an accelerated aging lifetime without failures.