Ductile end cross frames have been proposed in the past for seismic design of steel plate girder bridges. In this paper buckling-restrained braces (BRBs) are investigated as ductile end cross frames and compared against the performance of yielding X braces. Component experiments on the BRBs showed that these braces dissipated energy very efficiently and have stable hysteretic behavior. Shake-table experiments on a large scale bridge model investigated the performance of braces with both pin-ended connections and fixed-end connections. Despite slippage, the pin-ended connections are considered more effective as flexural action in the relatively short braces is prevented. The base shear in the bridge model in response to 2.0 times the El Centro earthquake was 69% of the elastic base shear at an average drift of 2.5% during experiments. The relatively large deformation capacity of the BRBs, although not as great as the X braces, is necessary to achieve a significant reduction in base shear. The maximum cross...
Ductile end cross frames have been proposed in the past as a seismic design and retrofit strategy for steel plate girder bridges. In this paper it is shown that with good connection details, single angles are able to undergo large cyclic deformations in excess of 6% average axial strain before failure occurs. Large-scale shake table experiments were performed on a straight steel I-girder bridge model to evaluate the performance of a superstructure with ductile end cross frames using single angle X braces. The cross frames exhibited no apparent overall strength degradation, but also a comparatively low postyield stiffness, allowing the cross frames to act as effective structural fuses. The measured base shear was 61% of the elastic base shear in response to 2.0 times the El Centro earthquake at an average drift of 3.4%. Large girder drifts were achieved without distress in the deck slab by removing selected studs between the slab and top flange of the girders at the end cross frame locations, with axial de...