30 November 2006 in Fluid Dynamics Research
14 July 2011 in Lab on a Chip
We experimentally study the dissolution of carbon dioxide bubbles into common liquids (water, ethanol, and methanol) using microfluidic devices. Elongated bubbles are individually produced using a hydrodynamic focusing section into a compact microchannel. The initial bubble size is determined based on the fluid volumetric flow rates of injection and the channel geometry. By contrast, the bubble dissolution rate is found to depend on the inlet gas pressure and the fluid pair composition. For short periods of time after the fluids initial contact, the bubble length decreases linearly with time. We show that the initial rate of bubble shrinkage is proportional to the ratio of the diffusion coefficient and the Henry's law constant associated with each fluid pair. Our study shows the possibility to rapidly impregnate liquids with CO2 over short distances using microfluidic technology.
22 November 2011 in Microfluidics and Nanofluidics
6 April 2012 in Biomicrofluidics
The evolution of carbon dioxide bubbles dissolving in water is experimentally examined using long microchannels. We study the coupling between bubble hydrodynamics and dissolution in confined geometries. The gas impregnation process in liquid produces significant flow rearrangements. Depending on the initial volumetric liquid fraction, three operating regimes are identified, namely saturating, coalescing, and dissolving. The morphological and dynamical transition from segmented to dilute bubbly flows is investigated. Tracking individual bubbles along the flow direction is used to calculate the temporal evolution of the liquid volumetric fraction and the average flow velocity near reference bubbles over long distances. This method allows us to empirically establish the functional relationship between bubble size and velocity. Finally, we examine the implication of this relationship during the coalescing flow regime, which limits the efficiency of the dissolution process.
24 March 2014 in RSC Advances
Droplet motion and dynamic wetting transitions are experimentally investigated over a wide range of viscosities and flow rates in square microchannels
25 November 2008 in Physical Review E
We experimentally investigate the flow structures formed when two miscible fluids that have large viscosity contrasts are injected and hydrodynamically focused in plane microchannels. Parallel viscous flows composed of a central stream surrounded by symmetric sheath streams are examined as a function of the flow rates, fluid viscosities, and rates of molecular diffusion. We study miscible interfacial morphologies and show a route for manipulating viscous flow-segregation processes in plane microsystems. The diffusion layer at the boundary of an ensheathed fluid grows as function of the distance downstream and depends on the Péclet number. In particular, we observe diffusion-enhanced viscous ensheathing processes. In the presence of a constriction, we investigate the formation of a lubricated viscous thread in the converging flow and also the buckling morphologies of the thread in the diverging flow. This study, relevant to multifluid flow between a “thick” material and a “thin” solvent, demonstrates the possibility to further control steady and oscillatory miscible fluid microstructures.