In the last decade, there has been an increased interest from the food packaging industry toward the development and application of biodegradable and biobased plastics, to contribute to the sustainable economy and to reduce the huge environmental problem afflicting the planet. In this framework, the present paper describes the synthesis of novel PBS (poly(butylene succinate))-based random copolymers with different composition containing glycol sub-units characterized by alkyl pendant groups of different length. The prepared samples were subjected to molecular, thermal, diffractometric and mechanical characterization. The barrier performances to O2, CO2 and N2 gases were also evaluated, envisioning for these new materials an application in food packaging. The presence of the side alkyl groups did not alter the thermal stability, whereas it significantly reduced the sample crystallinity degree, making these materials more flexible. The barrier properties were found to be worse than PBS; however, some of them were comparable to, or even better than, those of Low Density Polyethylene (LDPE), widely employed for flexible food packaging. The entity of variations in the final properties due to copolymerization were more modest in the case of the co-unit with short side methyl groups, which, when included in the PBS crystal lattice, causes a more modest decrement of crystallinity degree.
3,3″-Di[(S)-(+)-2-methylbutyl]-2,2′:5′,2″-terthiophene, having two equivalent reactive positions, allows the synthesis of the corresponding optically active poly(thiophene) with regioregular enchainment by using an aspecific oxidative polymerization method.
15 August 1999 in Journal of Polymer Science Part A: Polymer Chemistry
Main chain conjugated linear polymers, constituted by alternating electron-donor (D) and -acceptor (A) moieties, have been prepared with the aim of testing their performances as photoactive components in single material organic solar cells (SMOSCs). The D moiety is constituted by bithiophene co-units bearing in position 3 of the thiophene ring a hexyloxy, a hexyloxymethyl or a hexyl group, while the A moiety is represented by the benzothiadiazole group. The D–A polymers were obtained in high yield through the poorly demanding oxidative FeCl3 polymerization process – starting, respectively, from the related precursors 4,7-bis(3-hexyloxythiophen-2-yl)benzo[c][2,1,3]thiadiazole, 4,7-bis[3-(6-methoxyhexyl)thiophen-2-yl]benzo[c][2,1,3]thiadiazole and 4,7-bis(3-hexylthiophen-2-yl)benzo[c][2,1,3]thiadiazole – with low dispersity indexes, close to the monodisperse state, after fractionation with methanol. The materials have been thoroughly characterized for their physical and structural properties and then tested for photoconversion efficiency in SMOSCs by using different deposition procedures of the photoactive component. In agreement with Kelvin probe force microscopy (KPFM) measurements, the best photovoltaic performance was observed for the polymer based on conjugated 3-alkoxythiophene and benzothiadiazole moieties, achieving significant photocurrents for this type of fully conjugated alternating D–A structure (Jsc = 2.63–3.72 mA cm−2).
20 February 2018 in The Journal of Physical Chemistry C