The coating of hollow alumino-silicate microspheres or cenospheres with thin layers of Cu by means of vibration-assisted magnetron sputtering yields a starting material with considerable potential for the production of new types of metal matrix syntactic foams as well as optimized variants of conventional materials of this kind. This study introduces the coating process and the production of macroscopic samples from the coated spheres via spark plasma sintering (SPS). The influence of processing parameters on the coating itself, and the syntactic foams are discussed in terms of the obtained density levels as a function of sintering temperature (which was varied between 850 and 1080 °C), time (0.5 to 4 min), and surface appearance before and after SPS treatment. Sintering temperatures of 900 °C and above were found to cause breaking-up of the homogeneous sputter coating into a net-like structure. This effect is attributed to wetting behavior of Cu on the alumino-silicate cenosphere shells. Cylindrical samples were subjected to conductivity measurements and mechanical tests, and the first performance characteristics are reported here. Compressive strengths for Cu-based materials in the density range of 0.90–1.50 g/cm3 were found to lie between 8.6 and 61.9 MPa, depending on sintering conditions and density. An approximate relationship between strength and density is suggested based on the well-known Gibson–Ashby law. Density-related strength of the new material is contrasted to similar findings for several types of established metal foams gathered from the literature. Besides discussing these first experimental results, this paper outlines the potential of coated microspheres as optimized filler particles in metal matrix syntactic foams, and suggests associated directions of future research.
Ceramic materials have become of high industrial importance in some applications as their properties outperform ones of metallic components. However, use of ceramics is limited due to the difficulties in shaping. Electrically conductive ceramics can be machined by Electro-Discharge Machining (EDM) irrespective of its hardness or strength. In this study, yttria stabilized zirconia (YTZP) conductive composite was produced by incorporation of the cost-effective graphene coated alumina nanofibers (ANFC) into the matrix. Almost fully dense YTZP/5 vol.% ANFC nanocomposite was obtained by spark plasma sintering (SPS) at 1250 °C with uniaxial pressure of 40 MPa. Scanning electron microscopy observation of the microstructures showed that ANFCs were homogeneously dispersed in the matrix. Addition of ANFC resulted in slightly decreased mechanical properties, but the electrical resistivity of the composite dropped 9 orders of magnitude compared to monolithic zirconia, exhibiting 1.4 Ω∙m, satisfying the required condition for the EDM.