15 April 2020 in IEEE Transactions on Antennas and Propagation
A concurrently-dual-polarized, simultaneous transmit and receive (STAR) antenna system with high transmitreceive isolation is presented. The STAR antenna consists of four dual-polarized patches, two for transmit (TX) and two for receive. The radiators are fed using a network consisting of four 90° hybrids and four 180° hybrids. The input ports of the feed network constitute the input/outputs of the STAR antenna system. The system supports concurrent transmission and reception of waves with both right- and left-hand circular polarization. Due to the phase cancellation and geometrical symmetry of the antenna, the TX/RX coupling between ports with the same polarization is canceled using the feed network. Additionally, four right-angle slots are inserted in the ground plane and a cross-shaped, highimpedance surface is inserted between the radiating patches to further suppress the coupling between the differently-polarized TX and RX ports. Simulation and measurement results of a fabricated prototype show good agreement and demonstrate TX/RX isolation levels greater than 38 dB for all polarization combinations over a 6.5% bandwidth (6.0-6.4 GHz). Moreover, the fabricated prototype provides broadside axial ratios below 2.5 dB and realized gains above 7.8 dBic for all TX and RX modes, demonstrating a good, concurrent-dual-polarization performance.
7 December 2017 in IEEE Transactions on Antennas and Propagation
In this paper, an X-band electronically steerable parasitic array radiator (ESPAR) of circularly polarized dielectric resonator antennas (CP-DRAs) is proposed. The array consists of one driven CPDRA coupled to four parasitic CP-DRAs. The parasitic elements are placed adopting a sequential rotation approach and are terminated by tunable varactors to steer the beam into the desired direction. The proposed CP-ESPAR technique eliminates the need of expensive phase shifters, which significantly reduces cost and fabrication complexity. For performance evaluation, a prototype of the proposed antenna is designed, fabricated, and measured. It is observed that the proposed antenna has a monotonic CP beam scanning from – 22° to 22° operating at 10.5 GHz. In addition, the peak value of the realized gain is 6.6 dBic with 0.9 dB variation within the entire scanning range.
17 May 2017 in IEEE Transactions on Antennas and Propagation
MCMohammad Reza Chaharmir
A large array of dielectric resonator antenna (DRA) is designed in $X$ -band based on electrically steerable parasitic array radiator (ESPAR) concept. This large array consists of 240 perforated DRAs, which are uniformly excited by a parallel-series feeding network. By employing the perforation technique, the need for aligning and bonding individual DRA is eliminated. The subarrays are placed in an interleaved arrangement to suppress the grating lobes. To best explore the differences and advantages of our approach, the proposed ESPAR is compared with the beam steerable reflectarray antenna and traditional phased array antenna. The present large ESPAR can incredibly reduce the number of phase shifter by 80% in comparison with the conventional phased array, which makes it inexpensive. A prototype is fabricated, which achieves a maximum boresight realized a gain of 22.4 dBi. The agreement between measured and simulated results is very good.
27 February 2020 in IEEE Transactions on Antennas and Propagation
We present a systematic method for designing dual-polarized, platform-mounted, high-frequency (HF) antennas for near-vertical incidence skywave (NVIS) applications. To overcome the bandwidth and efficiency limitations of electrically-small antennas, the characteristic mode (CM) theory is used to exploit the metallic platform as the main radiator. Low-profile coupling elements are mounted on different locations of the platform to excite two orthogonal, horizontally-polarized CMs. This way, dual-polarized operation is achieved with a high isolation and sufficiently-wide bandwidth. In the design process, several key practical issues are taken into account and their impacts on the performance of the antenna are examined carefully. These include the type and design of the coupling elements, the presence and type of the earth, and the non-idealities and power handling capability in the impedance matching network components. The simulation results of both a full-scale and a 1:50 scaled model of the proposed structure are presented. The scaled-model prototype was fabricated and characterized in the presence of a ground plane emulating the properties of real earth at the scaled frequency of operation. The measurement results show a good agreement with the simulations, demonstrating the efficacy of the proposed approach in designing dual-polarized, platform-based HF antennas.
5 January 2018 in IEEE Transactions on Antennas and Propagation
A two-element tunable biomimetic antenna array (BMAA) that uses a single varactor to achieve tunability over a relatively wide band is presented. The proposed device consists of two closely-spaced quarter-wavelength monopole antennas operating at 600 MHz. The antennas are spaced at a distance of 2.5 cm and are coupled together using a tunable external coupling network (ECN). The ECN is designed to allow for tuning the response of the BMAA over the frequency range of 580-700 MHz. Over this frequency range, the proposed BMAA can enhance the phase difference between the output signals compared to a conventional array while extracting the maximum available power from the incoming wave. A prototype of the proposed tunable BMAA is designed, fabricated, and experimentally characterized. Measurement results are shown to be in good agreement with the theoretical analysis. The proposed tunable BMAA can be used to alleviate the bandwidth limitations of the previously-reported two-element biomimetic antenna arrays.
9 March 2020 in IEEE Transactions on Antennas and Propagation
We present a design strategy for platform-based antennas operating on electrically-small platforms such as unmanned ground vehicles (UGVs). Specifically, we report the design of a platform-based antenna operating at the lower end of the VHF band for a small UGV with physical dimensions of 99 cm × 67 cm × 39 cm. The antenna is mounted on the bottom of the platform resulting in an extremely low profile design and generating vertically-polarized, monopole-like radiation patterns. Using characteristic mode theory (CMT), performance metrics of the antenna including its maximum potential bandwidth and radiation patterns are investigated. The performance of the antenna when operating in a realistic operational environment is analyzed using full-wave electromagnetic simulations. A full-scale prototype of the antenna mounted on the bottom of the vehicle was fabricated and experimentally characterized. Finally, the design of this low-profile antenna is extended to a two-element antenna array mounted on the same platform and a prototype of this two-element array was fabricated. Basic experiments were conducted to study impedance matching and mutual coupling effects in this electrically-small antenna array. The performance of this array as part of a two-element direction-finding system was investigated through computer simulations.