15 October 2015 in Nature Communications
Few-layer black phosphorus (BP) is a new two-dimensional material which is of great interest for applications, mainly in electronics. However, its lack of environmental stability severely limits its synthesis and processing. Here we demonstrate that high-quality, few-layer BP nanosheets, with controllable size and observable photoluminescence, can be produced in large quantities by liquid phase exfoliation under ambient conditions in solvents such as N-cyclohexyl-2-pyrrolidone (CHP). Nanosheets are surprisingly stable in CHP, probably due to the solvation shell protecting the nanosheets from reacting with water or oxygen. Experiments, supported by simulations, show reactions to occur only at the nanosheet edge, with the rate and extent of the reaction dependent on the water/oxygen content. We demonstrate that liquid-exfoliated BP nanosheets are potentially useful in a range of applications from ultrafast saturable absorbers to gas sensors to fillers for composite reinforcement.
7 August 2014 in Nature Communications
Two-dimensional nanomaterials such as MoS2 are of great interest both because of their novel physical properties and their applications potential. Liquid exfoliation, an important production method, is limited by our inability to quickly and easily measure nanosheet size, thickness or concentration. Here we demonstrate a method to simultaneously determine mean values of these properties from an optical extinction spectrum measured on a liquid dispersion of MoS2 nanosheets. The concentration measurement is based on the size-independence of the low-wavelength extinction coefficient, while the size and thickness measurements rely on the effect of edges and quantum confinement on the optical spectra. The resultant controllability of concentration, size and thickness facilitates the preparation of dispersions with pre-determined properties such as high monolayer-content, leading to first measurement of A-exciton MoS2 luminescence in liquid suspensions. These techniques are general and can be applied to a range of two-dimensional materials including WS2, MoSe2 and WSe2.
21 April 2015 in Chemistry of Materials
Here, we demonstrate the production of large quantities of gallium sulfide (GaS) nanosheets by liquid exfoliation of layered GaS powder. The exfoliation was achieved by sonication of the powder in suitable solvents. The variation of dispersed concentration with solvent was consistent with classical solution thermodynamics and showed successful solvents to be those with Hildebrand solubility parameters close to 21.5 MPa1/2. In this way, nanosheets could be produced at concentrations of up to ∼0.2 mg/mL with lateral sizes and thicknesses of 50–1000 nm and 3–80 layers, respectively. The nanosheets appeared to be relatively defect-free although oxygen was observed in the vicinity of the edges. Using controlled centrifugation techniques, it was possible to prepare dispersions containing size-selected nanosheets. Spectroscopic measurements showed the optical properties of the dispersions to vary strongly with nanosheet size, allowing the elucidation of spectroscopic metrics for in situ estimation of nanosheet size and thickness. These techniques allow the production of nanosheets with controlled sizes, which will be important for certain applications. To demonstrate this, we prepared films of GaS nanosheets of three different sizes for use as hydrogen evolution electrocatalysts. We found a clear correlation between performance and size, showing small nanosheets to be more effective. This is consistent with the catalytically active sites residing on the nanosheet edges.
18 February 2015 in Journal of the American Chemical Society