1 April 2021 in IEEE Transactions on Power Electronics
Turn- off time is an important condition parameter for insulated gate bipolar transistor (IGBT), which could provide useful information on the device junction temperature and its state of health. Currently, it is measured directly from the IGBT collector-emitter voltage V ce or indirectly from the gate side, which may cause problems of safety and complexity for a power converter operating in a harsh electromagnetic environment. To address the challenges, this article proposes a noncontact method to monitor the IGBT turn- off time from the PWM switching ringing in the converter output current. First, a phenomenon is observed that there are two switch-over points in the switching ringing current corresponding to the transition of IGBT turn- off voltage. Analytical analysis is performed with a high-frequency (HF) equivalent circuit to investigate the mechanism of the one-to-one temporal relationship. Then, the noncontact condition monitoring (CM) scheme including the HF switching ringing current sensor and the framework of CM system is devised. Finally, experimental work is carried out to validate the theoretical analysis and the effectiveness of the method. Research results show that the turn- off time of multi-IGBTs can be effectively extracted at the terminal of converter during system normal operation with electrically isolated safety.
18 April 2024 in IEEE Transactions on Power Electronics
The switching time of a Silicon Carbide MetalOxide-Semiconductor Field-Effect Transistor (SiC MOSFET) is a crucial parameter that provides valuable insights into the device's operational performance and health status. However, direct measurement of switching time from the drain-source voltage or gate-source voltage may pose challenges in terms of safety and precision. To address these difficulties, this study proposes a non-contact method for monitoring the switching time of SiC MOSFET using high-frequency switching oscillations in a DC-DC converter. The article begins by analyzing the high-frequency switching oscillation current in a Buck converter, investigating its generation mechanism, including the excitation source, equivalent circuit, and analytical expression. Subsequently, the initial amplitude of the switching oscillation current (Isw1), which shows an explicit dependency on the switching time (tsw), is selected as the feature for monitoring the switching time. Then, a non-contact monitoring scheme for SiC MOSFET switching time is devised, involving a high-frequency switching oscillation sensor and a calibration process to establish the Isw1-tsw characteristic. The effectiveness of the proposed method is confirmed experimentally, which exhibits outstanding electrical isolation safety and achieves ns-level accuracy under varying operating conditions.